Jump to content

How To Remove Small Ceiling Console On 08 Silverado?


Recommended Posts

Here is the GM Diagram for the roof console in the 08 Rado

 

 

gmLogoFlat.gif Service Information

 

2008 Chevrolet Silverado - 2WD | Sierra, Silverado (VIN C/K) Service Manual | Document ID: 1709839 Roof Console Replacement

1709828.gif

 

Callout

 

Component Name

 

1

 

Front Overhead Console Lens

 

2

 

Roof Console Screws (Qty: 2)

 

Notice: Refer to Fastener Notice in the Preface section.

 

Tighten

2 N·m (18 lb in)

 

3

 

Roof Console Assembly

 

Tip

 

  1. Disconnect the electrical connectors.
  2. If replacing roof console assembly, transfer all necessary components.

4

 

Roof Console Retainers (Qty: 2)

 

Tip

Pull down to disengage clips.

 

© 2008 General Motors Corporation. All rights reserved.

Link to comment
Share on other sites

Thanks Mike.......I have been wondering how to drop

the darn thing so I could fish out the beacon wires

for my yellow snowplowing warning light !!!!!!!!!

According to the VYU plow prep info. I have the wires

are tied to the ceiling light console mount.

 

So I guess I have to take out the light lens cover to

get to the screws.................geo

Link to comment
Share on other sites

yeah it is the same for the front, if you need the back (with DVD), here it is:

 

 

 

 

gmLogoFlat.gif Service Information

2007 Chevrolet Silverado - 2WD | Sierra, Silverado (VIN C/K) Service Manual | Document ID: 1746291 Roof Rear Console Replacement (with DVD)

1746255.gif

 

Callout

 

Component Name

 

 

Preliminary Procedure

Remove the video display assembly. Refer to Video Display Replacement .

 

1

 

Roof Console Assembly

 

Tip

  1. Pull down to disengage the retainer clips.
  2. Disconnect the electrical connectors.
  3. If replacing the rear roof console, transfer all necessary components.

2

 

Roof Console Retainer (Qty: 4)

 

© 2008 General Motors Corporation. All rights reserved.

Link to comment
Share on other sites

I assume just a pick to pull the light cover down to get to the screws so as not to mar anything?

 

That's correct...Use a pick or a trim tool to pop the light cover off and expose the two screws.

Link to comment
Share on other sites

  • 2 years later...

Archived

This topic is now archived and is closed to further replies.



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.