Jump to content

Carshow GM 1210 installation


Recommended Posts

Greetings all! I received an early Christmas gift of a CS GM1210 for my 2012 Avalanche LT with Bose, rear entertainment, blue tooth and a backup camera. I hooked everything up, but seem to have an extra connector (C3) on the GM1210-6 harness. Anyway, I turned it on for an operational check before buttoning it up and found I had no backup on the monitor. It was still up on the mirror, but not on the CS 1210. I also had limited sources on the rear entertainment. These units are supposed to be plug and play, but I must be missing something. The removed radio only had two plugs and my harness had three. I searched all over inside the dash for an extra plug, but found none.

 

Also, I was wondering just how and where does one connect the pink wire to disable the video unless in park. The instructions say to connect to the parking brake, but I see no connector there anywhere.

 

Any help would be appreciated much.

 

Thanks

Dick

Link to comment
Share on other sites

Mike,

 

Thanks for the thread link. I can find the yellow plug, but I'll be damned if I can lay my fingers on the area depicted in the picture.

 

 

PS: I took Walt's advice he gave to someone earlier and tapped in at the mirror. Piece of cake and all is well.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.