Service Airbag light help

[Wasekcj]

Hello, I bought a 2010 Silverado with a slight front end damage to the front right. Both airbags were deployed. The impact sensors are still intact they weren't damaged and I had the airbag module reset from a professional. Also I replaced both of the airbags is there something I missed I can't figure out the problem.

[Duelin]

Without guessing you are going to have to get a Tech 2 hooked up and see what is going on with it. Could be a bad component or a communication problem. Also if there was a bad component and you powered everything up you could have activated the module again. And on some of those modules you can only reset them once. Good Luck

[Wasekcj]

Without guessing you are going to have to get a Tech 2 hooked up and see what is going on with it. Could be a bad component or a communication problem. Also if there was a bad component and you powered everything up you could have activated the module again. And on some of those modules you can only reset them once. Good Luck

 

I'm getting 3 codes P0573, B0015 and B0022

You won't. You need an enhanced scanner capable of communication with vehicle subsystems. The generic scanners can only pull basic powertrain codes.

 

I'm getting 3 codes P0573, B0015 and B0022

[Duelin]

P0573

Brake Switch Circuit 1 High Voltage
The ECM detects an open or short to voltage on the signal circuit

Probable Cause

1. Short circuit condition
2. Faulty switch

 

B0015 and B0022 If I remember correctly are driver and passenger front seat belt Pre-tensioner circuits have failed to self test correctly.

[MikeNH]

I get no codes from my OBD scanner

 

You won't. You need an enhanced scanner capable of communication with vehicle subsystems. The generic scanners can only pull basic powertrain codes.

[MikeNH]

What codes are you getting? Diagnosing this is impossible without that.

[Wasekcj]

I get no codes from my OBD scanner