Jump to content
  • 0

Add 6 way power passenger seat to 2014 Sierra SLE


jambo

Question

Want to add a power passenger seat to my Sierra. Wife complains about lumbar support.

 

Does the wiring exist or at least a pigtail to plug in wiring harness?

 

Also if someone could comment on part numbers.

 

Really appreciate the help.

Link to comment
Share on other sites

3 answers to this question

Recommended Posts

The switch, wiring and motors are all integral to the seat. You would need 12v and ground run to the seat, unless it is already there. And of course a different seat. You can check for existing wiring at the seat connector. Terminal 2 is 2.5 ga (metric) red w/ brown tracer. Terminal 11 is ground 4ga (metric) black. The connector is on the outside lower edge of the seat track under a piece of trim. Move the seat forward, open the rear door and remove the end cap of the trim. Slide the seat rearward and pull the trim toward the front. There is a little red lock you have to slide then push to release the connector.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.