- 0
SUNROOF BY-PASSING CLOSED POSITION
-
Recently Browsing 0 members
- No registered users viewing this page.
-
Forum Statistics
245.8k
Total Topics2.6m
Total Posts -
Member Statistics
-
Who's Online 12 Members, 0 Anonymous, 1,565 Guests (See full list)
Question
Lawgiver
Hello Everyone,
Just purchased a 03 ZR2 Blazer. I noticed the sunroof is not stopping in the closed position. I searched through the owners manual and could not find one reference to sunroof operation but managed to find some info online. If I push and release the toggle switch to the rear, the roof opens and stops at the halfway position. Will not open all the way. If I push and hold the toggle in the forward position the sunroof will open to the vent position. If I push the toggle to the rear to close the sunroof, the roof will again open to the halfway position. I obviously have an issue going on. The sunroof is not stopping in the closed position at all or opening all the way. Motor sounds good, no clicking and/or binding. Sunroof slides w/out issue. Tracks look fine and nothing appears to be broken. In searching the net, I have found posts concerning re-calibration of the sunroof module and drive motor timing. I don't know how correct this info is. Also found a reference to a GM# 12333707 sunroof module as being faulty. Can these modules be tested at all?? Any assistance would be greatly appreciated. Thank you all for your time.
Regards,
Rob
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.