Using factory fog light switch when installing cube fog lights.

[NMsilverado]

Wondering if anybody found. Wiring harness that can be used to hook up to the factory fog light switch.

[crankman]

I am assuming you have fog lights and your just replacing them .Is that correct? Or you needing to go all the way to the push button the dash?

[nekkidhillbilly]

he is talking led cubes in the fog openings. these should plug and just wire to the cubes wires.

 

 

http://www.amazon.com/PartsSquare-Universal-Pre-wired-Connector-Harness/dp/B00Q3V06SQ/ref=sr_1_1?ie=UTF8&qid=1454536325&sr=8-1&keywords=9006+male

[NMsilverado]

Yeah I have the factory switch already. Just put on a aftermarket bumper and putting in the cube lights. Looking for easy ways to hook it up to the old switch. Most things I have found is splice and potentially use a resistor wire as well.

[NMsilverado]

Sweet thanks for the link to Amazon. Appreciate it. And to your knowledge would I have to do the resistor wire or should this adapter take care of that?

[crankman]

Okay I did the same put a aftermarket bumper and upgraded the fogs to PIAA LED. My new fogs came with a wire harness so only connection was to the existing foglight wires. I just had that one splice and done. I didnt use any resistor I just checked the new load on the wiring circuit to make sure I was good and they work fine. What bumper did you get?

[NMsilverado]

I have a fusion bumper. And so you just spliced at the old fog light harness? Because I just have the old connector just tied up as of now.

[crankman]

Good deal put a pic on here sometime when your done would like to see it. Yes to answer your question I just did a weatherproof type butt splice crimp and tie wrapped it underneath and there done.

[NMsilverado]

Sweet. Thanks man. I would put a pic but I have no idea how to. Thanks for the info.

[RyanbabZ71]

wrong section, this does not belong in the How to

 

Topic moved