Jump to content

Chevy Silverado 2500 2005 breaks


Recommended Posts

I have a 2005 Chevy Silverado 2500 i replaced the break lines and only can git fluid to the front passenger tire fluid giting to the abs box but not coming out ive bled by putting 20 psi in the Master cylinder and also tryed vy puping breaks still no luck. Also the abs box was replaced 4 mouths ago so I thought it went bad so i took and replaced it again under warranty and still same problem can eany one help thanks

Link to comment
Share on other sites

If you aren't getting brake fluid out of the abs controller, there is a problem with getting brake fluid into it, as even if the abs controller completely fails, you still must have brakes.

 

1. Did you bench-bleed the master cylinder?

2. Does brake fluid come out of both input lines to the abs controller if you disconnect the lines and press on the brake pedal?

3. If yes to 2, then does brake fluid come out of all 3 outputs of the abs controller if you disconnect the lines to the wheels when you press on the pedal?

4. Are you sure you put all the lines in the correct ports of the abs controller?

Link to comment
Share on other sites

FYI

Break: separate or cause to separate into pieces as a result of a blow, shock, or strain.

 

Brake: a device for slowing or stopping a moving vehicle, typically by applying pressure to the wheels. :happysad:

Link to comment
Share on other sites

FYI

Break: separate or cause to separate into pieces as a result of a blow, shock, or strain.

 

Brake: a device for slowing or stopping a moving vehicle, typically by applying pressure to the wheels. :happysad:

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.