Jump to content

Hard clutch pedal wont go down


Recommended Posts

Hey guys, so i am having problems with my Slave or Master cylinder. I have no clue why its doing this but with the slave cylinder not installed into the bell housing or attached to the clutch fork my pedal is rock solid. I took the master cylinder and slave cylinder apart, cleaned then, and even went the extra mile and blew compressed air from both sides of the line to get any debris out of the line, i than bled the system and my pedal goes to the floor the first couple of times then all of a sudden wont go anymore. When this first happened i assumed it was due to a bad clutch but again i took the slave cylinder off and tried without it installed and it still does this. Not sure as to why but it is pretty frustrating. I hope someone can chime in and help me out, i have checked the obvious (air in system ect)

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.