Jump to content

Archived

This topic is now archived and is closed to further replies.

Recommended Posts

I have a 2004 GMC 2500HD 4x4 6.0 gasser, and I am haveing a problem with the oil cooler lines leaking at where they connect to the block. I had them replaced under warranty at 29k miles, then they started leaking again around 70k miles so I had to pay out of pocket to get them replaced again, now they are leaking again at 160k. What can I do to fix this?

Share this post


Link to post
Share on other sites
I have a 2004 GMC 2500HD 4x4 6.0 gasser, and I am haveing a problem with the oil cooler lines leaking at where they connect to the block. I had them replaced under warranty at 29k miles, then they started leaking again around 70k miles so I had to pay out of pocket to get them replaced again, now they are leaking again at 160k. What can I do to fix this?

 

I would just go get some braided stainless steel lines to replace the stock ones. You will probably have to change some fittings but in the long run they would last longer since they are able to flex unlike the stock tubes are.

Share this post


Link to post
Share on other sites

Thanks for the info,

I am not sure if it is actually the lines themselves leaking or the actual block that bolts to the engine. I am going to clean the area real good and see where the leak orriginates from. The oil is covering where it mounts to the engine and runs down the oil filter.

Share this post


Link to post
Share on other sites

  • Popular Now

×

Important Information

By using this site, you agree to our Terms of Use.