Jump to content

jjarach

Member
  • Posts

    11
  • Joined

  • Last visited

Profile Information

  • Drives
    2017 Denali HD

jjarach's Achievements

Enthusiast

Enthusiast (2/11)

1

Reputation

  1. Rough Country said that only the 3.5 inch kit has angled blocks, would not send me new blocks even after showing them your picture and a picture of the blocks on my truck.
  2. The blocks on my truck do not look like that at all. They are a rectangle and Rough Country would not assist me at all. Now I know for sure that the rear blocks are the problem, uninstalling the kit this weekend.
  3. I downloaded the install instructions as well and it does not say the blocks are angled.1305.pdf 1305.pdf 1305.pdf 1305.pdf
  4. I just doubled checked and the blocks are definitely 2" f & R. I will call Rough Country to see if they should be angled. That may very well be the problem. Thank you very much
  5. I had them installed at a shop. But I just measured the blocks and they appear to be the same measurement front and rear. So I do not think they are angled.
  6. I had a RC 2.5" lift/leveling kit installed on my 14 Sierra and know I have a bad vibration when I accelerate quickly, especially when going over 55 mph and have to accelerate. I had the alignment done after the install and I have the stock tires and rims still on the vehicle. Dealer will not even look at it because of the lift. I hate to have to remove the lift, but I do not want to cause drive-line issues. Has anyone else experienced this problem? If so, how did you get rid of the vibration? Thank you in advance for any advice given.
  7. I would like a set as well if you decide to sell them. Sent from my iPad using Tapatalk
  8. Did the front light bar eliminate the tow hooks? I don't want to loose the tow hooks, that is why I haven't installed a bull bar. I really like this bar!
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.