TKhawk01

Has anyone found a wire for the 10 minute retained acc power? All of the ones I have found only retain power until the door is opened. I want to be able to leave the light on after I open the door but not be on a always on so I can't forget to turn it off and drain the batt. Right now I have my relay for my light triggered by a wire off of the high beam but I'm installing some double throw switches in the console so the bar can be off, on with highs, or on with 10 minute RAP. I'm also going to do the same for my backup pods along with a jumper from reverse to the bed lights.

Dang, I just drilled holes in my console for my switches last night. I should have checked up on this thread first, that remote would have been sweet.

Here are my installed pics. The zip ties have been replaced with two pieces of angle bolted together around the support bars. And the cut out.

I'll have to get some pictures after work, I thought I had some but I can't find them. The led is a Mictuning http://amzn.com/B00D7JKM9K it puts off great light but the first time I drove in the rain it fogged up and had condensation in it for a couple of weeks, once it dries out really well I'm going to add some silicon around it. As far as I know the head lights are stock, I haven't done anything to them. The truck was a demo that the finance manager drove. I am starting to think my truck had some front end damage that was repaired by the dealership. When I was pulling the grill to put the light bar on I noticed a couple of screws missing on the driver side inner fender liner and the plastic where the 2 lower middle bolts of the grill, bolt to was broken.

Here is my 37" single in my SLT grill, I did have to trim some of the plastic on the sides to make the 37" fit, you would have to trim quite a bit to get a 40" in there. vs low beam vs high beam

I was planning on just wiring my pods on the bed lighting circuit so that I could just turn them on whenever I wanted, but last night I noticed the bed lights would only turn on when the truck was in park. Does anyone know if there is a way to change this? Otherwise, I guess I'll either do like Toddfather or add a switch .

Mdmischief, where did you tap in to the high beam trigger wire? This looks like an amazingly clean way of turning the lights on. Thanks,