Installed the AMP Power Steps yesterday. Decided to take others' advice and wire it up first then install the boards. The very last thing to do, install the second board to the arms...I notice a huge gouge in the outside edge of the board, VERY noticeable.
Kudos to Summit for sending out an entire new system to pick a new board out of. Excellent customer service.
Has anyone with the AMP steps installed them without drilling the hole for the harness to pass through to the cab? Was wondering if anyone found a convenient access point that might already exist on the firewall, etc.
Do the plug-n-play version of the Amp PowerSteps actuate individually on each side? That is, when only the driver door opens, does just the driver step actuate or do both driver and passenger actuate?
Not sure if this has been covered or not. It's nothing awesome, just keeps your console a little cleaner looking.
If you use a USB connection to wire your phone or tablet you can route the wire down the inside edge of the console to the rubber tray below the dash. The lower edge is rubber and appears made to route and hide cables. Use one of the USB connections in the main bin and run the cable down behind the movable cup holder.
The cup holder can be rotated 180° and one looks like it's supposed to go one way but will work either direction. One direction does allow a little more room to run the cable however.