dkweeks

Sent from my SM-G920R7 using Tapatalk

I don't have any night pics but it is nice to have. I have the factory led headlights which are bright enough for everything, but the light bar goes over the top. I had a 36" double row behind the grille of my 14 Silverado and 4 20" bars behind the grille of my old dodge and this is just as good or better than those setups. Sent from my SM-G920R7 using Tapatalk

It is a 30" light bar. Rough country 70625 kit. Sent from my SM-G920R7 using Tapatalk

Installed this last month. Rough country single row light bar. It took about 45 minutes to install using the vehicle specific brackets from rough country. Sent from my SM-G920R7 using Tapatalk

There is a small circle on top of the large grommet in the driver side of the firewall. Cut a slit in it and fish your wire through. This is the method recommended for routing the power wires for the GM kicker system. Tip: remove the 3 nuts holding the power distribution box on the interior and move it slightly out of the way to make it easier to fish the wires through the firewall. I have installed my kicker power wires and rough country harness through here with no trouble. Sent from my SM-G920R7 using Tapatalk

this is what your bed rails look like without the caps. Sent from my SM-G920R7 using Tapatalk

My kids think it is fun how it vibrates the seat when it is turned up and they have their ears covered. They barely know it is there when listening to music at lower volume. Sent from my SM-G920R7 using Tapatalk

You have to see the dot lights in person. They have a very defined beam. They are way better than the factory fogs. I will have to do a better job aiming them and the spots but that will be tomorrow. Too busy watching football tonight..... sent from my Samsung Galaxy S6

About $340 for both sets and another $20 for the jumper harnesses. I have been watching amazon for a few months waiting for the prices to drop to an "acceptable" level. sent from my Samsung Galaxy S6

Just installed dual Rigid leds. One DOT version and one spotlight in each side. The dot is wired in the factory fog light harness with an h16 to deutsch jumper harness and the spotlight is relayed in with a trigger wire coming from the high beam. sent from my Samsung Galaxy S6

I installed this myself on a Friday night in about 2 hours with hand tools. You will cut your hands running wires under the dash and cuss when trying to run the wires through the firewall. You will also enjoy the part that everything is plug and play. Cost of the kit was $860 from iamgmparts. sent from my Samsung Galaxy S6

I don't have bose, but the separate amp gave my door speakers the extra kick they needed and the sub is good enough to rattle my teeth when I want to turn it up. It is a good system to upgrade the factory setup without looking like you went aftermarket. You can spend alot more for a perfect system, but I am happy with this. Hope this helps. sent from my Samsung Galaxy S6

I have this setup but it rubs a little when turning. I don't feel it going forward, but it is more noticeable in reverse. I have 0 offset 20" gear alloy big blocks with 33x12.50 toyo at2 extremes. sent from my Samsung Galaxy S6

That was my purpose when I modified the storage. Everything slides on the carpet when coming to a stop. This keeps it in place so my kids aren't stepping on things when getting out of the truck. sent from my Samsung Galaxy S6