snapring6r

I have a 2014 silvy with the exact set up you mentioned. I can probably count on one hand how many times the tires rubbed and that was in reverse at full lock going over uneven terrain. I say go for it, you'll be glad you did!

Anyone have any experience with running a 295/60/20 toyo open country AT2 on a RC 2.5" level? 20x9 wheels with a +18 offset. Factory mud flaps on a 2014 silvy. Rub? Thanks.

I think xm radio may be behind this! If your FM reception is terrible, how many owners will start paying for xm? Just a thought....

Did you do the piping just on the doors? How much of the piping did it take? Looks good! Its the small details that set one apart!

How about a 20x9 wheel with a +18 offset and 295\55\20 tires? RC 2.5 level. Rubbing?

The truck has been sitting for over 24 hours and the valve turns in either direction.

When looking straight on to the square on the flapper, do you rotate it counter clockwise to the open position?

Its a 4x9 oval, 14 inches long

Anyone running the magnaflow 11229? Thoughts?

Well with the flapper still in place, how can I get that very deep sound?

Looking for a very deep throaty sound, but not obnoxious. Don't want to spend a lot. Truck is a 2014 5.3. Have never heard the "drone" that everyone speaks of, so I don't know how I feel about that. Truck is basically stock. Any and all thoughts? Thanks guys.

Hey Matt in OK, your white Silverado is similar to the setup I'm looking for my white Silverado. Do you remember the offset on you wheels? I noticed you debadged it also, what were the steps you took doing that? Lookin' good!

Getting ready to install a RC 2.5" leveling kit with rear blocks, does any one have or know where I can find torque specs on all related components with this level kit, i.e. u-bolts, struts, etc

Hey guys, new to the forum, but have read a lot. Got a 2014 Silverado and getting ready to install a RC 2.5" level kit. Right now it has the stock alum 18" wheels, considering XD strike 20x9 with a +18 offset and 285/60/20 tires, but don't want them outside the fenders and no trimming or rubbing. Do any of you all have any experience with this setup? Any other suggestions? Thanks