Truckin 55

Had my K2 serviced and recalls fixed seatbelt, airbag reprogramed . Everybody will hear the sweet sound of the Corsa when I cruise up to Iowa this weekend.

Tire Chains and Deicer if going through higher elevations.

Corsa Sport Exhaust installed last month sounds great with no problems. Tightened clamps a little with 1/4 inch ratchet Thanksgiving and again few days ago with 1/2 inch drive. As others have mentioned a little loud cold start and assume slight popping is normal while decelerating. Just hear a low rumble on HWY with trans in 6th but in 5M very noticeable. Corsa to me has more of a Glass Pack sound compared to others and makes a warble sound in V4 mode. Range made a huge difference but quit working so sent it back last week. Range Tech just sent message Module has been serviced ,updated to Series 7 should be here Saturday

I asked Fondupot the same question, I have a 5.3 with PCV side of manifold , I just pushed end of hose to the barb, if it breaks you will need a new manifold

On 5.3 Elite 2 Connect hose to PCV connection below Throttle Body to Top of Can. Connect hose to side of can to PCV connection side of engine

Installed Elite2 similar to jrob56 yesterday but lost a clamp and couldn't finish with check valve. This morning went Auto parts store for clamps and Hose cutters, they didn't sell them and wouldn't lend the pair they use. Being a little irritated put he stuff back and went to a shop next door. They just had regular hose clamps but were nice enough to lend their cutters. Made one cut put on the valve and all I need to do now is trim ends off the Zip Ties.

When I visit my sister she always walks outside when I leave and was standing beside my truck when I hit the remote start. The Corsa really boomed in the carport making her jump and yell, then said " Cool I like that ! " Just doing my job as little brother

Checked out some new trucks while at Dealership today. The White High Altitudes have Flowmaster with Double Wall tips. The dark Trucks are from an unknown company had Glass packs about the size of a Liter soda bottle, Y pipe split into skinny pipes with crinkled bends with tips that looked like soup cans. The Aluma coat was flaking off and rusting ,can't believe someone would install that junk on a new truck