Spate47

Do you have any photos of your setup?

Curious if anyone has installed on of these yet or plans to in the near future? I was waiting for Banks to drop their intake and exhaust system for the '20/'21 L5P (to try and best pair them with my Deringer and Pedal Monster) but they continue to roll back the release date. https://afepower.com/afe-power-50-70056t-momentum-hd-cold-air-intake-system-w-pro-10r-filter

Having the same issue on our 2016 Tahoe. Hood and roof are both shot. Didnt surface until just after the 36K mark so any warranty is now DIW. Anyone else have any luck getting after Chevy to correct the issue? We just got stationed in Hawaii so we are being quoted well over 3k so repaint ...

Love the look! Did you install yourself?

Where did you get the rear block? It's really a 2" block to replace the factory block correct?

After much deliberation, I settled with a muffler delete and I clamped the valve open. More than pleased with the result. Letting it break in before I decide to go the AFM Range route as well. So far, the drone/chop is VERY minimal both inside and out. VID_80521103_195316_558_1.mp4

This x2

Did you stick with the stocks that came with the lift or upgrade to the hydro or Fox Adventure Series?

Sweet, thanks!! How is the ride quality?

Damn, nice! When are you gonna swap out lifts?? Thanks for the insight. I ran the math a few times but just wanted a sanity check.

Stock backspacing should be roughly 6" (6.06" for the sticklers). Zone states that 5.75" of backspace as the limit for running 35x12.50 on a 20" rim. So looks like a 1" spacer all around should do the trick?

Got into a new 2017 1500 All-Terrain earlier last year and just getting around to a lift. There are two shops close by that claim it would be near impossible to run a Zone 6.5 or anything similar with my stock 20x9s and 34/35 inch treads. Is this just a lazy approach by the shop I don't remember having such an issue with my 2014 that had 18" stockers, besides running spacers. Am I just barking up the wrong tree as far as the shops or am I missing something?

Looks great! Just picked mine up today too with 2" front and awaiting tread decision. Glad I still had about an inch or so of rake left.

Went with 2" RC. Ride loss VERY minimal. Waiting on treads until we know for sure if we are moving to Hawaii or not. More than happy with the stance. I wanted some rake left up front for any light towing/hauling.

Sharp looking rig! What are you running up front? And may just be the angle, but anything in the rear?