As far as Ive read, you will have no trouble with rubbing with the 17's 0 offset and the 285/70s. I cant speak for the 305/55r20's. I even went up an inch and I only had to pull the liners back with a zipty
I too am from California and am partial to the lean. I leveled mine front only and was thinking about removing the rear blocks. Its crazy how different the angle is on those two pics. Makes me think removing the block wont even make a difference lol
17x8.5 Method Mesh rims
0 offset 4.75" backspace
285/75r17 Toyo ATll's
2.5" level (front only)
rubs at full lock both directions. (will hopefully be able to correct that as i just installed them)
Well was finally able to save enough to have a productive weekend.
Installed an RC 2.5" level upfront
Removed front air damn
Added Method Mesh 17x8.5 0 offset wrapped in Toyo ATll 285/75r17's
Installed 14" Magnaflow exhaust dumped after the axle
5% Tint all the way around
Installed XB Led fogs (man were those a PITA!)
Attempted to install a 55w Silverado Spec kit from TRS, but had a bad ballast.
(still waiting on a K&N intake)
So I am contemplating getting some 17x8.5 0 offset Method NVs wrapped in either 285/70r17 BFG KO2 or 295/70r17 Nitto Terra Grap G2s.
I am aware that the 295s might rub but I'm confused on where. Sway bar, liner or metal?
any input would be appreciated!
Will be running a 2.5" RC level as well.