ottawasierra

Here's mine Sent from my iPhone using Tapatalk

I like that the antenna hits, early warning Sent from my iPhone using Tapatalk

Rough country. I wanted to go higher, but didn't want to cut up the truck and also it still fits in most under ground parking. Sent from my iPhone using Tapatalk

I put the bigger blocks in the rear as well. No problem with the lights when towing the boat and stuff. Sent from my iPhone using Tapatalk

I also have a 2.5" levelling kit. Sent from my iPhone using Tapatalk

They rub a tiny bit at full lock (Control arm??) I think it's a width issue and not a hight issue. They don't rub the fender liner at all. With stock 18s I don't think you would get 305/65s without a bunch of rubbing. Sent from my iPhone using Tapatalk

They are 295/65/18 Goodyear Duratracs. I love them. They look great, aren't too noisy and are winter rated. Sent from my iPhone using Tapatalk

Got a bath and was looking somewhat clean...and then it snowed and freezing rain. Can't wait for summer. Sent from my iPhone using Tapatalk

Here are some more pictures of the lights in pieces: Sent from my iPhone using Tapatalk

I used krylon fusion. I think it's all in the prep..I scuffed the surface and used adhesion promoter.

Haha, I probably would have stressed less about breaking them if I was baked...but you gotta move quick to get the lense off before it hardens. So probably wouldn't be a good idea.

The baking is just to soften the glue to be able to remove the headlight lense. Then you can paint the chrome housing inside. I did it cuz the chrome lights looked funny on my black truck. It was stricktly a cosmetic thing. As for light output, our trucks use projectors and do not use the housings to project the light. Therefor painting the housings does not change the light output. Removing the turn signal lense does reduce the turn signal output, but I bought REALLY bright LED bulbs and they can be seen just fine. Hope that answers your question.

Click on the pics and it will open them in imageshack. They were too big to upload. If you can't see them send me a PM with your email and I can send you the pics. I did not remove the previous sealant. Some of it came out when I was prying out the lense, but otherwise I didn't remove it. the retro rubber becomes super gooey and fills in all the gaps when you squish the lense back into the housing.

Here is the link: https://www.theretrofitsource.com/accessories/build-materials/morimoto-retrorubber-butyl-glue.html If you go on YouTube there are videos of how to use the stuff. What kinda pics are you looking for?

I didn't like the look of the clears, make it look cheap and "ricer" looking. But that's just my opinion. Plus they are crazy expensive.