2002 Silverado 200k
I pulled the trans to replace the rear main seal and put the truck back together and now I get no response when I turn the key to start.
For troubleshooting I have:
Replaced the NSS, both of the NSS pigtails
No start, dash is indicating gear, reverse lights activate.
Pulled starter and had it tested it multiple times and its good
If I connect a test lead to the solenoid it turns over but dies after a second.
If I apply 12v to the purple/white wire and the orange wire in the NSS harness the starter relay clicks.
If I connect those two wires together and jump the solenoid the truck starts and stays running.]
12v is good from battery to starter, ground is clear.
NO 12v at the 12v solenoid wire at key turn.
Assuming this is my issue is it a common thing for the ignition switch to go bad and cause this? Could i have broken the wire while working under the truck?
Am I missing anything that I should be testing?