SpartanAutoworx

some require programming.

Also 20759945 The part number for 2007 08 and 09 vehicles is on national backorder right now.

P069e most common code for bad FSCM. New ones must be programmed to work. Before replacement you need to check a few wires at the FSCM for proper power. The green and white wire is common for breaking along with a bad pcm. Diagnosis is key before spending any hard earned money for parts that might not fix the problem at hand. get on YouTube and you will find a few good vids on properly diagnosing the FSCM.

Don't worry about the other wires just check for the two powers. I've never seen any other issues in that slice pack.

What is your email ? The file size is too large to attach

Look up the connector for c397 The two orange wires should have 12volt battery positive voltage If that other wire is dead I would say you need to trace it back for a break in the wire. I bet you put 12volts to the wire you will be back in business.

Right side of vehicle Passenger side I'm used to customers always thinking it's looking through the window. So passenger-side the right side four pin connector with two orange wires.

could be a bad bcm

Check for voltage on the left rear pillar should have one connector with 4 wires. Two of them should be orange in that connector of a pretty good gauge wire. I bet you have voltage to only one of the orange wires.

Could be a bad BCM if its not wiring.

99-07 classic The cluster must be flashed / reprogrammed for transmission temp

99-07 classic The cluster must be flashed / reprogrammed for transmission temp

This requires a custom VCI from GM. I rather pull my own teeth as you'll wait on the phone for four hours plus for the custom vci to be made.

I dont have a diagram in front of me but I have done this swap a few times. If memory recalls me correctly on some connectors on the column harness it had different designations. If you remove one from a salvage yard just mark the location of each pin.

Buy a used frame and treat it with por15 before swapping. I have done many frame swaps and its not difficult just time consuming for someone that has never done one.