audioworks04

Did you ever get this install finished? Did you have to raise your seat?

I am a little old school and am running an elemental designs 9.2 amp to an elemental designs 10in 11kv.2 sub in a single sealed box under the passenger side rear seat. I cut my underseat organizer down to still work with the box in place. It isn’t loud, but it is clear and plays surprisingly low. Sent from my iPhone using Tapatalk

Any idea what he did without removing the covers? Sent from my iPhone using Tapatalk

86k on my 15 and the drivers is dead, out if warranty so I guess I’ll wait winter is over and I can ride the bike to work while I tear a seat out and replace it. Sent from my iPhone using Tapatalk

Will the inverter allow it to dim? I would think that as the inverter saw a voltage drop it would shut down. Sent from my iPhone using Tapatalk

Short answer is yes, but depends on the region you live in as frost and ground heaving might be a concern. Sent from my iPhone using Tapatalk

How was the install? Remove the leather cover and getting it stretched back on properly has me a little leary of attempting this.

Has anyone found the heating element to purchase other than from the dealer, and if so where and cost? How is the install?

20% on front side windows to match oem rears. Sent from my iPhone using Tapatalk

I wouldn't waste money on an off brand light bar that wide, almost everyone I have seen with one on bows in the middle and ends up resting on the roof. And personally in my opinion a roof mounted light bar really ruins the looks of these trucks. Sent from my iPhone using Tapatalk

http://www.foxacoustics.com/ProductDetails.asp?ProductCode=GM%2DCC%2D110%2DV%2D07 I do not personally own, but as soon as I can talk myself out of loosing all of my under seat storage this one is on the top of my list. Sent from my iPhone using Tapatalk

No, not legal as they are "for off road use only" and not dot approved. Also they will not be functional as fog lights, more so driving lights that will most likely blind other drivers. Sent from my iPhone using Tapatalk

I have bose and tapped wires off the bose amp to the bose sub for signal to my lc2i. Crystal clear with zero problems. I cannot emphasize enough how awesome the lc2i is. I have ran plenty of cheap converters in the past with mediocre results, this blows them all out of the water. Sent from my iPhone using Tapatalk

Another vote for the audiocontrol LC line. LC2i in mine with zero issues or complaints. Sent from my iPhone using Tapatalk

The color of the base coat doesn't matter as you are only removing residue from the top surface, clear coat. Only time this applies is on older single stage paints and even then it is fairly safe with the exception of high metallics. Sent from my iPhone using Tapatalk