-
Posts
189 -
Joined
-
Last visited
-
Days Won
1
Ichie123 last won the day on May 6 2018
Ichie123 had the most liked content!
About Ichie123
- Birthday 04/04/1994
Profile Information
-
Name
Ryan Gannaway
-
Location
Mississippi
-
Gender
Male
-
Drives
2015 GMC SIERRA SLT
Recent Profile Visitors
3,149 profile views
Ichie123's Achievements
Enthusiast (4/11)
58
Reputation
-
2014 Silverado miss fire rough ride
Ichie123 replied to Fahad Safdar's topic in 2014 - 2019 Silverado & Sierra
Fuel pump. Possibly. Just had to replace ours. After a horrendous battle with the dealer misdiagnosing our issue. -
Pillars are from a 2015 Sierra 1500 Sent from my iPhone using Tapatalk
-
Ichie123 changed their profile photo
-
Wtb or trade the A pillar on passenger side without handle. I have the one with handle and need one without handle for a project I’m doing for fabricating speaker pods. Will upload pics of mine later.
-
Wire backup camera - help
Ichie123 replied to GoBlue2014LT's topic in 2014 - 2019 Silverado & Sierra
There’s a lil grommet under both the driver floorboard and passenger front floorboard. Both in the same locations. You’ll have to pull the carpet up but it would be just where your left foot ( driver seat) rests while sitting. Vice versa for passenger side. So it’d be your right foot. Sent from my iPhone using Tapatalk -
Speaker Pods? for Front Door Component Speakers
Ichie123 replied to FishNJ's topic in 2014-2018 Silverado & Sierra Mods
Those are usually fabricated. -
What have you done to your K2 today?
Ichie123 replied to block8head's topic in 2014-2018 Silverado & Sierra Mods
Right now the tweeter is on the door on the black piece trim and sits right above the dash when you close the door. No I wasn’t able to get the 4” to sit in the dash. [emoji24] if I had the right tools I might be able to cut into the dash where the factory hole is to make it sit in but right now the magnet is preventing it from sitting due to not enough depth. I’m planning on fabricating the pillars to hold both the 4” and the tweeter so that they’re both facing towards each respective seat. I would say definitely do the 3 way. The sound is just so much more distinctive than the 2 way. So for now the dash panel piece is just sitting on top with the pillars holding it in place. -
What have you done to your K2 today?
Ichie123 replied to block8head's topic in 2014-2018 Silverado & Sierra Mods
I installed the Hertz ESK 163L.5 for my front stage powered by the Alpine PDR F50 4 channel amp. Bridged the outputs to run 140watts to each channel. I messed up with the dash speakers. So will end up fabricating the pillars to hold the tweeter and 4” midrange.... eventually. Whenever I have time. Sounds phenomenal. And overall very pleased with the sound. -
The lcq1 is the upgrade from the lc7i. I didn’t have to upgrade my speakers. I had originally wanted to keep the factory HU until the alpine came out and had planned to upgrade all my speakers with it so I went ahead and got the lc7i. Do note I had the Bose audio so the sub wiring was already there to take the signal from. Sent from my iPhone using Tapatalk
-
Most total miles per engine hours...
Ichie123 replied to scott.moody.9401's topic in 2014 - 2019 Silverado & Sierra
118644miles 2602.8 hours =45.58 -
Passenger rear. On the wall. Right above where the jack is roughly. Sent from my iPhone using Tapatalk
-
Could be either. I had the same issue a few months after i got mine. I can’t remember exactly which one i replaced as I’ve had to replace both the relays and the igniter. Sent from my iPhone using Tapatalk
-
Try swapping the relays with new ones. Just Bc you can hear them clicking doesn’t mean they’re working. My sisters were clicking but wasn’t turning on. Replaced with spare relays i had a viola. If it’s not that it could be the igniter going out. I think that was my first replacement.
-
how to bypass bose amp my15+
Ichie123 replied to xps800doo's topic in 2014 - 2019 Silverado & Sierra
-
how to bypass bose amp my15+
Ichie123 replied to xps800doo's topic in 2014 - 2019 Silverado & Sierra
Not all the connections. Just the speakers wires. Everything should work the same. The amp is still powered and working in the background. The bose amp just powers the speakers. Onstar and all of that are on another module.
-
Forum Statistics
246k
Total Topics2.6m
Total Posts -
Member Statistics
-
Who's Online 3 Members, 0 Anonymous, 590 Guests (See full list)