caskey_b

I also sent pm please let me know if you have these. I will buy them

I’ll take them. Pm me your PayPal

$100

Bump

$125 shipped

Sold

have a part number?

Opt7 has a y splitter that plugs into the 4way on trailer

glad i found this thread and now know that I am not the only one experiencing this... purchased a BRAND NEW set of OEM projectors to install on my LT and had the same thing happen after a decent rain, and a decent temp change.... Ill be going with the moisture packet deal if it continues to be an issue

i have my own... ill give her another shot... now that i have it painted... maybe itll look better since the paint is covering the outer edge... thanks

see... i tried vinyl first... didnt like it... vinyl wouldn't conform down into the gaps around the perimeter of the bowtie... and could always see gold

what did you use on the steering wheel bowtie? i just did mine as well (with plastidip) not 100% satisfied with it so may do it again

I just did the bowties on my wheels as well... i used vinyl and then sprayed a couple coats of clear over the caps...

got the front bowtie done and put back on... i have masked off the wheel center caps and doing those in black too... next will be the bowtie on the steering wheel... after that, all gold bowties will be BLACK!!!! if i could only change the programming on the computer to have the one on the dash and radio be black..... .pgamboa??? thoughts? hahaha... kidding

not sure who makes it... but with dry filters... i just check them periodically... every 7500-10000 miles usually... you can literally just tap them clean... or if a little dirtier, rinse them (opposite of airflow) and let air dry.. really depends on the roads you drive... i live on gravel, so i typically clean them every 10k or so... some may not need it til 15 or 20k