nlindste

I had the same issue with mine, I uninstalled the app and reinstalled it and it solved the problem for me.

I used this wiring harness from amazon to tie into my factory lighting system. I have 2 rigid flush mounted lights in the pockets on the rear bumper. It has zero effect on the trailering system. All I did is tied into the connector. https://www.amazon.com/OPT7-Redline-Connect-Harness-Silverado/dp/B09YCD82H3 https://www.amazon.com/Rigid-Industries-Diffused-Resistant-Accessories/dp/B01HJ4G9QI

That light output is excellent, so much brighter that the LED's I put in my reverse lights. One of the best upgrades I have done other than the lightbar in the grill.

Here is how it turned out.

I used the Putco quick connect harness on my 22 when I installed my Rigid auxiliary reverse lights. Not the cheapest but, high quality and have had it installed for a year without issues. It completely avoids tapping into the factory lights. https://www.amazon.com/529005-Connect-Harness-Silverado-Sierra/dp/B07V82RZNT These are the lights I installed into the pockets on the rear bumper. https://www.amazon.com/gp/product/B01HJ4G9QI

I have had this issue before with both my 22 Silverado, and my 19 RAM. The common thing I had done was replace some of my bulbs with LEDS, which I believe might be causing RF interference based on some research I have done. When I took the bulbs out the keyfob not detected message stops coming up.

I have the same issue with mine ever since the lifters were replaced. I betting that air got into the coolant system and just needs to be bled off. Nick

There is definitely no way to get it without ripping the grill off. Yeah the light that you have I really don't think would fit without major modification.

I am not sure if it would fit, because the bracket lines up perfectly with a spot where one of the tabs clip in, the double row would put the bar in the way of the tab in the center.

Mine has the active shutters too. From what I have read, if I had picked up a curved bar I wouldn't have had to modify the active shutters. I only had to trim a little bit on the lowest row of shutter.

I have this mount that I used for a single row 30 inch straight LED bar. https://www.americantrucks.com/silverado1500-20-inch-luminix-led-light-bar-grille-mount-light-brackets-2221.html I followed this video for help. https://youtu.be/VhA1y1iNe9I I will try and get pics of my setup later.

I had a similar issue with my prior RAM 1500 that the dealership couldn't figure out. I had changed my 3rd brake light, reverse lights and cargo lights to aftermarket LEDS. The cheaper LEDs I had used were causing radio interference which interrupted the signal from the key fob. Not sure if you have aftermarket LEDs in the truck but that could be a place to start.