Search the Community
Showing results for tags 'bumper removal'.
Found 1 result
-
(Pictures are not uploading properly, I will fix it when I can and put them in the appropriate places in the post) I want to start off by saying, pictures are limited, as the only bolts you need to remove (10 total) are fairly obvious and in your face, the only two that are 'difficult' to find I will explain where they are. I special ordered my truck how I wanted it with every option I needed, but I left off the chrome package because I don't like chrome. But then my dad bought a black LT RCSB and I loved the chrome bumper so I decided I had to have one while I look for all blue color matched (Z71) front end parts. The first part that needs to come off is the plastic trim under the hood, that is on top of the radiator/grille. There are 10 push-pins that hold it on. I used the second tool in the picture, lift the first stage of the clip, once its up about 3/4 inch, get under the base and pull it completely out. Next, the grille is held on with 4 10mm bolts, these bolts don't do much honestly. Pulling the grille itself out was the most challenging part of the whole job. There are clips in front of each bolt that will slide back in their slots if you breath too hard. On the middle/driver's side clip, there is a plastic locator pin that appears to be nearly impossible to leave intact and remove the grille, so I cut it off flush - there are enough pressure clips to keep everything aligned. I started at the passenger side and removed the top clip, then pulled the grille out at the middle cross piece. Don't be afraid of pulling too hard, the pressure clips release with some force. Once the grille pull out approximately 1", you can lift the grille up and out. This leaves the bumper. There are a total of 6 bolts that attach the bumper to the truck, 4 accessible now that the grille is removed, the other 2 are harder to get too, one on each side. If you lay down in front of each tire and look up, you will see the brace that secure the bumper. Remove the one 15mm bolt that on each side (leave side with 2 bolts on the frame). Now you can remove the four 18 mm bolts that are in front of the radiator. The bumper should rest on its mounts once all bolts are removed without a risk of falling, but be careful regardless. That will leave you with something that looks like this, kind of intimidating at first. I had to transfer all the appropriate brackets from my back bumper to my chrome one, a little bit of effort but if you have gotten this far you won't have an issue. Then everything goes back together exactly the opposite as it came apart.
