Search the Community
Showing results for tags 'electrical fubar'.
Found 1 result
Hello, I recently bought a 2000 GMC Sierra 2500 extended cab SLT 2wd with the 5.3L. I was very excited about this truck initially as I got it at a great price, but I am starting to become overwhelmed with all of its problems I recently discovered. The previous owner purchased this truck at an auction, and put a lot of new parts on it mechanically and cosmetically. There are a lot of mis-matched parts on this truck and I can tell it is somewhat of a "Frankenstein." One thing I noticed is that there are 4x4 buttons on the dash, even though this is a 2wd truck (no T-case). So obviously someone put a new dash on from a 4wd donor. Also, the plastic around the ignition cylinder looks like its been monkeyed with, so someone was probably fooling around near the steering column. When I test drove the truck, the only light on was "Service Engine Soon." However, when I brought my truck to get an OBDII scan at the parts store it returned 14 codes (some duplicates) which are as follows: B0017 - Passenger frontal deployment loop open B0024 - Driver deployment loop short to ground B0036 - Discriminating sensor open or short to voltage B0051 - Deployment commanded C0265 - EBCM relay circuit P0430 - Catalyst system - Low efficiency (Bank 2) P0440 - EVAP system P0449 - Evaporative canister vent solenoid control circuit But, NO lights are ever on the dash except the SES. Shouldn't the airbag or SRS light be on as well? On startup the only lights that come are the SES, nothing else. All the gauges work, although they bounce oddly when I shut off the truck. The voltage needle also twitches very slightly when I use the turn signal. Also, when I turn on the headlamps, the only thing lit up is the cluster. The radio, climate controls, and everything else is dark. And, when I cleared the codes with the ODBII scanner, the radio went off and reset itself to 1:00?! I have literally spent hours on end searching in vain for a definitive answer to this host of problems with only little success. I am guessing that the "B" codes mean that I need a new SDM? Perhaps this truck was in a wreck? P0430 might be because of a small exhaust leak this truck has, or possibly the cat is bad. P0440 and P0449 might mean I need a new EVAP solenoid or can? Please help me, it would be greatly appreciated. This truck means a lot to my little family as it is how we are getting across the country for my new job in Tallahassee. Any insights would be very welcome. Thank you all.