Search the Community
Showing results for tags 'flush'.
-
I recently bought a great used 2007 Silverado 5.3 2wd with only 78k miles. I seen the carfax that the trans fluid was changed at 15k. So I decided to flush the system. But now I’m nervous that it might’ve been a bad decision and I might have done more damage in the long run. The flush didn’t include a new filter either so I might have it changed. Anyone think it’s going to deteriorate sooner or later?
-
I was at the dealer the other day getting a tire replaced and I noticed I needed a coolant flush as its been 5 years and no previous one. When I got home I checked the reservoir and it was grossly overfilled. I doubt there's room for 7oz of expansion in it. I know sometimes this happens because it needs to burp out some air so I've driven it a couple of times but it hasn't gone down yet. I've got one of these coming tomorrow to suck the excess out if it hasn't gone down tomorrow but wondering if anyone knows about burping these or how to remove air. There doesn't appear to be a radiator cap which is likely why the reserve tank is pressurized. https://www.amazon.com/gp/product/B07CP8R9MS Since these are pressurized reservoirs, it seems that a grossly overfilled can cause damage as there's nowhere for the pressure to go except the weakest link which is likely a hose or fitting. My question is do these heater cores have a valve or is coolant running to them constantly? It is dead summer and I want to avoid heat on full to see if it clears out if I can. Also judging by design, it seems like it would naturally burp itself fairly quickly. Before the flush my needle almost always stayed constant at 210 when warmed up, now it seems to fluctuate between the 197.5 mark and 210 which leads me to think either there's still air in there or the overfill is causing excessive pressure that is altering the temp.
-
So I'll make this topic as detailed and informative as I possibly can because I'm running out of options here. Video of the issue is included. I did a coolant and radiator flush on my '03 Sierra 5.3 to change the coolant from green ACDelco to orange Prestone. All the old coolant was flushed out of the engine and in with the new. The radiator was bled properly. After driving around for a while, I noticed my temp gauge starting to rise just above midway on the highway, and I can hear the fans kicking on high (did an electric fans swap). I didn't think much of it, but then it refused to cool down even though both the fans and the outside air are blasting through the radiator, and I know that the radiator is clean because there was no corrosion on the inside or outer debris blocking the airflow. I took it back to the shop, reflushed it, bought a new OEM thermostat, nothing helped. As a last resort, I did the following things to make sure everything is working correctly, and I'll mention some notes: *Thermostat has been replaced *Coolant was changed back to green 50/50 ACDelco, which faired a bit better than the orange Prestone. *Changed the temp sensor and its wiring *Bought a new fan harness from Nelson Performance because the old one got busted from how long the fans were running on high. *Radiator hoses were inspected, nothing is cracked or kinked. *Oil is not milky, nor getting smoke from the exhaust, and I'm not losing coolant, so no head gasket issues. *Car was running fine before the flush. *The car isn't drastically overheating, but there's no reason for the temperature to rise on or above midway when I'm cruising down the highway, and this will make the fans and the harness run harder. *This only happens after I push on the gas or the engine is underload such as cruising on the highway. *Sometimes when the car is idling, it takes awhile for the low fans to turn off, as in, it is cooling down slower than usual. The only two things that are left to suspect are the water pump (not leaking or making noise though), and that there is an air pocket trapped in the engine, and I'd appreciate if someone tells me how to check if there is one. If this behavior is normal, which I'm sure it isn't, please let me know. Here's the video. When the temp begins to rise I'm cruising around 55mph, and only cooled down when I came to a stop and slowly took off again. https://youtu.be/J5jeolKdtc8
-
I did a coolant flush on my 5.3 '03 Sierra and changed the fluid from green to Prestone orange coolant. I had mild overheating issues prior to the flush, so I figured flushing the coolant and changing to orange Prestone might help (I did the same exact thing in my '04 GTO with LS1 and haven't had overheating issues since forever). Now the temp always goes above midway, and here's the thing... It does the same thing even on the HIGHWAY with fans on high speed, and it sometimes goes down in traffic only (basically when I'm not giving the engine any acceleration). I changed the coolant again with dexcool, and did an air bleed, changed the temp sensor and thermostat two months ago, and cannot see any leak from the pump but still nothing is helping. I'll note that the green coolant didn't look dirty when it I flushed it out, and that it only heats up when I'm accelerating.
-
Good morning guys, Obviously I'm new to the forums, so thank you in advance for your understanding! A little background on my situation -- I always make sure to maintain my vehicle to the best of my ability (both proactively and within my financial budget), but my Chevy Silverado just hit it's 75,000 mile mark with no previous transmission fluid maintenance. 2011 Chevy Silverado 1500 (Standard Work Vehicle) Pre-Certified with 3,008 miles on it, pretty much brand-new -- Purchased in Oct, 2013 4.3 Liters V6 Engine 75,600 miles currently The only thing it's ever towed is the smallest Uhaul for about 600/miles, and sod back in the day. For the past couple of years I've only driven it to and from work (50 miles round trip in city/highway), but for the most part this past year my new place of employment is super close, so that dwindled to around 25 miles round-trip. I've only ever replaced the engine oil and filter regularly, and tires a year ago, so when it comes to how I should maintenance the transmission oil, that's a bit foreign to me unfortunately. I've heard if you make it passed 70k with no issues, it's not wise to flush it out entirely, but more so the 50/50 (old/new) method? I would like some advice from you tenured vets on this, and to see if I should take it to the Chevy dealer or a transmission specialist? Thanks again!
- 4 replies
-
- 2013
- transmission
-
(and 6 more)
Tagged with:
-
Hello all! A few months ago I purchased a 2006 Silverado 2500 with the 6.0 Vortec engine. My coolant is slightly discolored and there seems to be a little scale inside the tank. I would like to backflush the system, but I am not entirely sure how on this truck. My Chiltons manual says to remove the thermostat and reinstall the housing by itself, then hook up a garden hose to the radiator and backflush. 2 chapters later, the same manual says that the thermostat is part of the housing and cannot be removed! Any advice?