Search the Community
Showing results for tags 'mrt motorsports'.
Found 2 results
-
I recently purchased the Fox 2.0 full set from MRT and will be installing on my 2017 Silverado Z71 cc. Planning on leaving it at the 2 inch mark but would like to also add 1-2 inchs in the back. The Fox site says the rear 2.0's are good from 0-1 inch in lift so I'm not sure what size block to go with. I had my eyes on the Motofab 2 inch blocks but what I don't know is if these are 2 inch blocks that replace the 1.25's on the truck now, raising it .75 inch or do they actually raise the rear a full 2 inches. If that's the case, will the 2.0's in the rear be over extended? Will a 1 inch lift block (again from MRT) raise the truck 1 inch above the stock 1.25 and be the preferred route to go? Thanks in advance for any assistance.
-
We were out at the Mint 400 Race this past weekend and Ford had on display the 2017 Ford Raptor. With loads of new features, bigger shocks and now an Ecoboost engine this Raptor is ready to battle. We like the look, what do you all think? Shot with GoPro (Sorry for the wide angle) #MRTMotorsports #VegasOffroad #2017FordRaptor- 33 replies
-
- 1
-
-
- 2017 ford raptor
- ford raptor
- (and 5 more)
