Search the Community
Showing results for tags 'multiple cylinder misfire'.
Found 2 results
Ok, so here's the deal my truck keeps throwing the P0300 code (multiple cylinder misfire) and we can't figure out what is wrong with it. We've changed the knock sensor, the crank position sensor, changed the whole distributor to a MSD billet distributor (street fire model), changed plugs and wires, changed the coil. None of them have changed the fact that it keeps throwing this code. I also have the upgraded acdelco Spyder injection system. The motor is a freshly built 383 stroker built by a reputable engine builder when we first started the truck it ran like shit so we sent the computer to blackbear and had it tuned to the motors specs. When we got the tuned computer it in the truck it ran a hell of a lot better but it still keeps throwing this code. If anyone can point me in the direction of what could possibly be wrong or point me towards a good tech for these truck it would be greatly appreciated.
p0300 obdii code
handymann posted a topic in 1996-2018 Chevrolet Express & GMC SavanaHELP? Throws p0300 code. Idles rough with noticeable miss. Not even driveable. Ignition side: Replaced plugs,wires,cap,rotor,coil swapped in known good igniton module,swapped in known good crankshaft position sensor. Exhaust side: swapped in known good EGR valve, dropped y-pipe and checked for exhaust restriction. Fuel system: checked fuel pressure 48 psi. book says should be 60-66. okay maybe on to something. Replaced fuel filter. Checked fuel pressure bleed down. seemed to bleed down tooo fast . suspected regulator leak. 1997 express 2500 5.0l v8 by the way. injectors and regulator located under upper intake manifold. Sooo i installed the MFI injector upgrade while i was in there. no help. checked voltage drop at the pump it was only 1.2volts so i changed the one year old fuel pump with new delphi unit. no help. vacume guage reads 17-18hg steady. checked for any vacume leaks best i could with propane and carb cleaner. hard to get to with van access. seemed okay. checked engine compression warm with 150 psi lowest and 165 psi highest. ANY IDEAS? on where to go next.