Search the Community
Showing results for tags 'power window'.
Found 4 results
Hello, my airbag service light came on last week and I thought it was due to the recall that is on this model. I had the recall fixed and the light is still on. Plus my power seat and passenger windows won't work. I checked all of the fuses and modules with no luck. Has anyone else had this issue and if so what was wrong. Thank you!
Looking for some help with this 2016 silverado, the passenger door says it's open and the power window won't work. We looked at the connections at the hinge point of the passenger door and all connections in the door, I haven't found any bad fuses, and I'm not really sure where to go from here. Any help would be great.
My rear drivers side window would not come down. This just started the other day. It would not work with the front or rear switch. no humming from the motor. Fuse is OK for the left side windows. I swapped out the switch from the passenger side and still didnt work. However the driver's switch worked fine on the other side. I then removed the regulator assembly by having to cut the cable since the window was up. I removed the motor and bench tested it and it ran with 12V put to it. This leaves just the main front door switch assembly. My question is would a bad front switch cause the back switch not to work?? Also when I press the switch , I get a brief buzzing sound from the switch. Also with the motor connected, it still isnt turning so it wasn't a jammed cable on the regulator. I am getting to the end of what I can troubleshoot, and I hope it doesn't turn out to be a bad wire in the door harness. Any suggestions would be greatly appreciated.
cjessee73 posted a topic in Gen III and IV Small Block & DrivetrainI'm new to the forum. I have a 2006 GMC Sierra 1500 Crewcab 4x4 SLE. My problem is somewhat intermittent. Mostly on rainy days the drivers door lock and all of the controls on the drivers door will not work until in unplug the unit for a few minutes, then it will usually work. Also this is an old company truck that was used in a limestone quarry for the last year or 2 before I bought it. My question is, if unplugging the switch assembly gets everything to working again, is the switch assembly the likely culprit causing the issue or is it possibly something else? Any help will be greatly appreciated. This truck has heated seats and memory for the seat and mirrors. The mirrors are also power folding and auto dimming with turn signals. One additional note is that the power drivers seat and seat heaters for the drivers seat have not worked in quite some time. Thank you for any help.