Re-level after installing Ranch Hand bumper?

[hosedragger134]

Hey guys. I recently installed a leveling kit from Rough Country on my 2014 Silverado. Today I received and installed a Ranch Hand Bull Nose bumper on the same truck. I expected there to be a bit of sag but not nearly as much as I ended up with. The truck went back to looking stock! What will be the best way for me to re-level the truck?

[SouthernSilveradoGuy85]

I say adjustable struts. It will probably ride stiffer on the front though since you might have to put it on a stiffer setting.

Edited February 26, 2015 by SouthernSilveradoGuy85

[hosedragger134]

I'll have to look into a pair. Any suggestions on a good set?

[SouthernSilveradoGuy85]

Bilstein 5100

 

I think you end up using the OEM spring and other parts for the spring so it's not a quick replacement.

Edited February 26, 2015 by SouthernSilveradoGuy85

[MORSNO]

You guys realize that this is the HD forum right? There are no adjustable struts for a HD.

[SouthernSilveradoGuy85]

You guys realize that this is the HD forum right? There are no adjustable struts for a HD.

 

Actually I didn't notice lol, my mistake.

[KMGZ400]

How much are the keys cranked up? All you'll have to do is jack up the front end and crank the keys up a few turns

[kstruckcountry]

It shouldn't pull the front end down much at all on an HD.

 

My 2006 half ton isn't even an inch low, that's a 9 year old pickup with ~150 pounds on the nose. Torsion bars have never been cranked up. I've seen 4x4 pickups with the stock bumper lower.