Help with front turn signal wiring on 2017 LT

[chrispassas21]

Got it


Sent from my iPhone using Tapatalk

What was the problem??


Sent from my iPhone using Tapatalk

[Jmiller11331]

When you unplug the MAF sensor, you have to reset battery


Sent from my iPhone using Tapatalk

[Jeremy D. Steele]

Now do you need 3ohm for each rear bulb or are you putting a 3ohm in upstream? Also, where could I locate the front wiring harness for the turn signals to wire in upstream?  And, lol, has anyone used resisters for the headlights?  Are they needed and will they be brighter if I use them?   

Thanks,

JS

[nate_0022]

I was going to install the gold resistors on my truck but after searching around I found the VLR6 resistors from VLEDs. I was able to connect them to the wiring by the actual turn signal on the headlight instead of the main harness. These resistors come with a disconnect so if you have to pull the headlights out you can disconnect them from the actual resistor and the wiring is long enough so you can mount them on the body of the truck and away from the headlight since resistors do get hot. Just a thought for people looking into resistors. 

 

https://www.vleds.com/shop-products/vlr-resistors/turn-signal-resistors/vlr-6-duotap.html

[DEV1ST8R]

2 minutes ago, nate_0022 said:

I was going to install the gold resistors on my truck but after searching around I found the VLR6 resistors from VLEDs. I was able to connect them to the wiring by the actual turn signal on the headlight instead of the main harness. These resistors come with a disconnect so if you have to pull the headlights out you can disconnect them from the actual resistor and the wiring is long enough so you can mount them on the body of the truck and away from the headlight since resistors do get hot. Just a thought for people looking into resistors. 

 

https://www.vleds.com/shop-products/vlr-resistors/turn-signal-resistors/vlr-6-duotap.html

I second the VLEDS - they are awesome. Mine don’t even get hot to the touch and have worked flawlessly for a year now.

[Jeremy D. Steele]

I have the disconnect resistors for the headlights, just haven't installed them because I want sure if I needed them. I have no warning. Does it make them any brighter? 

[nate_0022]

Resistors don’t make anything brighter. They help with hyper flash when switching to LEDs

[Jeremy D. Steele]

8 minutes ago, nate_0022 said:

Resistors don’t make anything brighter. They help with hyper flash when switching to LEDs

I knew they didn't on turn signals. I just have a set of resistors for the headlights and want sure why I'd need them. Thanks

[1BigDog]

On ‎10‎/‎6‎/‎2017 at 10:42 AM, pgamboa said:

Driver Side

Pin 1 - Black = Ground

Pin 7 - Dark Blue/White Stripe = Turn Signal

 

Passenger Side

Pin 1 - Black = Ground

Pin 7 - Light Green/Purple Stripe = Turn Signal

 

 

Sent from my iPhone using Tapatalk

I got the wiring colors for the turn signals and grounds at the harness, but what color is for the running lights(parking lights)?