Jump to content

bgbdwlf2500

Installed GMC logo projector

Recommended Posts

as far as I can tell they are sealed as far as the lens and housing. I think the only place water can get to them would be where the wire comes out of the housing but that is inside the step so just the wire is truly exposed once it comes out of the step. Wiring connections could be an issue though. mine are connected up next to frame.
Adhesive-lined heat shrink is your best bet in that application.

Steve
2012 2500hd 6.0l

Share this post


Link to post
Share on other sites
12 minutes ago, sdeeter19555 said:

Adhesive-lined heat shrink is your best bet in that application.

Steve
2012 2500hd 6.0l
 

I just wish the wires that come on them was bigger. Its like 22 or smaller.

Share this post


Link to post
Share on other sites

Why are you advertising for GM when you are not getting paid to? 

Share this post


Link to post
Share on other sites

Any body try these in their mirrors?  I am installing some tow mirrors in my 2017 Silverado and am going to try to tie these into the puddle lamp circuit.

Share this post


Link to post
Share on other sites
8 hours ago, mammut said:

Any body try these in their mirrors?  I am installing some tow mirrors in my 2017 Silverado and am going to try to tie these into the puddle lamp circuit.

I considered it but figured there wasn't enough room on a regular mirror so I didn't even attempt it.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×

Important Information

By using this site, you agree to our Terms of Use.