ReadyLift UCA's

Rad_Rado17 · November 8, 2018

Installed the cognitos today.

kylant · November 9, 2018

15 hours ago, shadrickjm said:

Installed the cognitos today.

where did you end up getting them? price??

did you have to "chase" the knuckle for the ball joint stud as mentioned in the install instructions?

how about the frame pocket bump stop, did you cut that off?

thanks

2k10CrewCab · November 9, 2018

1 hour ago, kylant said:

where did you end up getting them? price??

did you have to "chase" the knuckle for the ball joint stud as mentioned in the install instructions?

how about the frame pocket bump stop, did you cut that off?

thanks

On mine I had to chase the knuckle and didn’t cut the bump stop. Just removed the rubber piece off it.

Rad_Rado17 · November 9, 2018

2 hours ago, kylant said:

where did you end up getting them? price??

did you have to "chase" the knuckle for the ball joint stud as mentioned in the install instructions?

how about the frame pocket bump stop, did you cut that off?

thanks

If you wait you can get them on ebay with the 10-15% off discount codes. I think it's around $450 with the discount.

Edited November 9, 2018 by shadrickjm

PSU23 · February 13, 2019

On 11/3/2018 at 3:32 PM, 2k10CrewCab said:

Yea I was running stock 18s with 265/65 tires no rubbing issues. I just went to a 20x10 -24 with 33x12.5 tires and no rubbing issues either with this new setup.

You were running the 2.25 lift with 33 / 12.5”? Any NorCal mod or trimming needed?

Also, for those installing the ReadyLIFT UCAs, did you have any issues with the bearing spinning during UCA install since it doesn’t have a an Allen key to prevent spinning?

Edited February 13, 2019 by PSU23

2k10CrewCab · February 15, 2019

On 2/12/2019 at 7:40 PM, PSU23 said:

You were running the 2.25 lift with 33 / 12.5”? Any NorCal mod or trimming needed?

Also, for those installing the ReadyLIFT UCAs, did you have any issues with the bearing spinning during UCA install since it doesn’t have a an Allen key to prevent spinning?

I have a 2.5” leveling kit. I had to trim the plastic on the back of the wheel well and zip tie the liner back.