Sign up for FREE! Become a GM-Trucks.com Member Today!
In 20 seconds you can become part of the worlds largest and oldest community discussing General Motors, Chevrolet and GMC branded pickups, crossovers, and SUVs. From buying research to owner support, join 1.5 MILLION GM Truck Enthusiasts every month who use GM-Trucks.com as a daily part of their ownership experience.
Looking to lift the front end of my 06 GMC Sierra 1500 2WD to lessen some of the factory rake. I have about a 3.5in difference from the back to front. Looking for about 2-2.5in of lift in the front. Any suggestions on what i can do to get the lift and if you have any product recommendations that would be great. I don't mind paying a little extra for something of good quality. Thanks!
I have a 2013 GMC Sierra 1500 SLT that I just bought and I am looking to hookup an after market subwoofer and amp but I like the stock dash look so I don't want to replace the stock radio (which would make this process a lot easier). Would I just replace the stock sub and amp and splice into the current wires? Could I keep the stock sub and amp also while connecting new sub and amp? Does the stock radio have RCA connectors in the back that I can connect too?
In a perfect world I would be able to add a new sub and amp without replacing the stock sub and amp and still have a high quality sound system without using RCA plugs since I do not think they come on the back of the stock radio.
I have been looking at adding a couple of cameras to my 2019 GMC Sierra 2500HD Denali. These trucks can be difficult to pull into parking spaces and lots, especially if they are smaller. I just recently raised the front end about 2-3 inches, this has made parking a even bigger challenge. Yes, when parking I try to back into most of the parking spaces, but sometimes that option isn't available.
The system I have been looking at is from Echomaster, this system is listed under GM accessories and is labeled Intellihaul. The multi-camera system comes complete with a interface module, wiring, two (2) cameras that are mounted within a black mirror trim piece that attaches to the bottom of the mirror. The trim level on my Denali comes with trailer towing mirrors that are all chrome, and I really didn't want to substitute the lower black trim pieces in place of the chrome. I have seen one and it didn't look that good, on the all black mirrors they look OK (Just my preference).
Echomaster has just recently released a new 3rd brake lamp camera that has three (3) different viewing angles within a single camera, a right 95 degree, a left 95 degree and a rear 90 degree. Then all I would have to do is add the front facing camera. In this arrangment, I would have to utilize a multi-camera module, this module is complete with wiring harness, bracket and OEM interface jumper cable. However, the new released 3rd brake lamp camera only has one (1) video output. I would have to hard wire 3 more input triggers to make this function correctly, the left and right turn signals and reverse triggers. To operate on the OEM radio screen, I would have to depress the "back" button for three (3) seconds until the camera icons appeared on the screen. This would give me the rear cargo area. To view both the blind spot camera views, I would have to cycle the left or right turn signal depending on which camera I want to view. I would also have a front facing camera installed in the grill area, which would assist in parking manuevers. In this setup, I still would have full operation of the OEM backup camera when in reverse. I think this would be a good option and give me what I was looking for.
When I talked to the tech assistance at GM this afternoon, he said that the system would be awkward to operate. I would like something that is plug-n-play, a system that I didn't have to rely on to take to dealer to program the radio, BCM or any other related modules.
What is everyone doing about adding cameras to your truck, what sytem and options have you looked at and/or are utilizing?
Do you like your truck with the camera addition?
What are your thoughts?
GM has available now factory camper mirrors! Time for a nice run down on them and what is involved.
What they are: Factory tow mirrors. https://accessories.chevrolet.com/product/extended-view-tow-mirrors-in-black-84731241?year=2020&make=Chevrolet&model=Silverado%201500&categoryId=98023
Price? Part #? 84731241 is the #, MSRP for the mirror package is $730.
What do they feature? Includes lower convex spotter glass, as well as cargo lamps, clearance lamps and integrated turn signal indicator. Manual extend and manual fold.
-GM has factory tow mirrors available as an accessory for trucks that don't have them!
- 2020+up ONLY at the moment. They do NOT list them for 2019.
- They DO REQUIRE HARNESS SWAPS. Both front doors require new door harnesses.
- If you have the front spotter lights in the mirrors or have blind spot alert, THESE WILL NOT WORK!
- BCM calibration required for ALL models to make all lighting function.
If you have the dealer do it, its about 3.6 hours.
Harness numbers will be listed below:
2020-2021 Crew and Double Cab with KEYED ignition and DLF mirror: 84622369 and 84622370
2020-2021 Regular Cab with KEYED ignition and DLF mirror: 84622376 and 84622380
2020-2021 Crew and Double Cab with PUSH BUTTON ignition and DLF mirror: 84622371 and 84622372
By Kolton Leslie
I have an aftermarket stereo in my 2006 GMC Sierra 2500HD with the Bose sound system. Currently, i only have one speaker working, the other 3 have no sound coming from them. Any idea what could cause this? or a work around for the Bose system. Im tired of listening to my music through one speaker.
Recently Browsing 0 members
No registered users viewing this page.
Most OnlineNewest Member
Who's Online 113 Members, 0 Anonymous, 2,321 Guests (See full list)
- Jeremy Lowery
- Farmer Brown
- Doug Cleary
- Poodle Head Mikey
- Jason Yaeger
- Jeff Winkler
- Eddie 70
- Crazy Schooner
- Shawn Fox
- Marcel Almeida
- Daniel Lopez
- asci computer
- Chase Voudren
- Dave Smith