Jump to content
  • Sign up for FREE! Become a GM-Trucks.com Member Today!

    In 20 seconds you can become part of the worlds largest and oldest community discussing General Motors, Chevrolet and GMC branded pickups, crossovers, and SUVs. From buying research to owner support, join 1.5 MILLION GM Truck Enthusiasts every month who use GM-Trucks.com as a daily part of their ownership experience. 

Rudger

2019 GMC Emblem Installation

Recommended Posts

Do the OEM black GMC emblems come pre-assembled with the black insert attached to the chrome?

Share this post


Link to post
Share on other sites

Check out this vid - I really like how the gloss black and matte black turned out.  Does anyone know if I remove the rear badges from tailgate, am I able to reinstall them after painting them?  New double sided tape??

 

 

Share this post


Link to post
Share on other sites

Thanks for the removal tip, I just gone done replace my front emblem. 

Share this post


Link to post
Share on other sites
On 7/5/2019 at 5:37 PM, BringTheRain403 said:

BTW the way you did this is the way GMC instructs their techs to do this. I have the official GM instructions and I can scan them and post them here if anyone would like to see them...

 

Sent from my Pixel 2 XL using Tapatalk

 

 

 

Hey, could you PM me those instructions?

Share this post


Link to post
Share on other sites
On 2/3/2019 at 10:02 PM, Rudger said:

Hey all,

 

I installed the OEM black GMC letters on my AT4 this weekend and thought I would pass this shortcut along.  If you don't mind being a bit destructive and want to take the easy route - just pry the red insert off of the factory emblems and it exposes the retaining clips.  Insert a screw driver and they pop right off.  No grill removal required.  I had one or two tangs that didn't immediately snap back in on the new emblems.  apply a bit of pressure to the grill tab with either your finger or a flat blade screw driver from behind until it clicks.  You are good to go.

 

 

20190202_151922.jpg

20190202_151932.jpg

20190202_151938.jpg

20190202_151941.jpg

Firstly, Thank you for this, you saved me a lot of time.  But I have a small request  -Can you better explain the best way to clip them back in?  The G sounded like it clipped in, the M didn't sound like it, but seems to be OK, and the C can slide in and slide out (It's not clipping in).  Where are you applying pressure to clip them in...from under the hood with the hood popped?  A huge storm is about to hit my area, and I can't fit in front of the truck with the garage door shut to try to finagle this to clip in, at the moment.  Hope to get a response so I can clip it in first thing tomorrow morning.   I appreciate your help.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.




×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.