Jump to content
Mace

4x4 stuck in 4-lo 2000 Silverado 1500

Recommended Posts

Hi, have had my 4x4 acting up with no lights on the selector switch and was driving fine in 2wd. Now when starting it up again it was stuck in 4-lo, Dealer had scanned it and said the fault code was coming from the encoder motor wich I will replace tonight. My problem is that I’m told the new motor comes in nuetral, can someone help guide me as how to get the t-case into neutral position???

Share this post


Link to post
Share on other sites

The quick and easy way is after you've removed the original encoder motor, just a pliers or wrench to turn the shift shaft to the neutral position. You'll know it when you can spin the driveshaft (make sure truck is properly supported off the ground).

Share this post


Link to post
Share on other sites

Been a while but I did use that guidance and everything went well! Thank you 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.