Jump to content

Bmayz

Heated/vented switch

Recommended Posts

Hows it going guys! I have a 2017 sierra denali that was crashed and i rebuilt little by little. The last piece to the puzzle is pretty much just her the heated/vent switch to turn on, so i can check if my seats work(hot/cool). I have check the fuses on 43/44 that the fuses claims are the two seats. Both are good. When i try to push the switch/button to turn on the heat or vent they just dont turn red or blue. Like if there isnt any power to them. I dont know what other fuses i might need to check but maybe yall can help me out. Any information would be grateful! Thank you!

Share this post


Link to post
Share on other sites

Do you have power at the back of the switch?

Share this post


Link to post
Share on other sites

If you haven't already done so, check out the electrical specs for the seats on pages 1238-1243 in the Body Builder Manual...https://www.gmupfitter.com/pdflists/view/39 then click on "full size" then "sierra...chassis applications" then "electrical". Its too big to upload here (71MB). It also looks like underhood fuse 34 goes to the switches (schematic pg. 306), but it also controls other stuff like the display and AC control module so if they work then its good. You can check the individual pins in the connectors under the seat to see if there is power coming that far. Anything else not working that might can help isolate?

Edited by NCPGMC
additional info added.

Share this post


Link to post
Share on other sites

I havent taken out the bezel to check if there is power behind the switch. But, everything in the truck works. Only thing not powering on are the driver and pass switch. Ill check that fuse(34) but ac and display all work.

Share this post


Link to post
Share on other sites

Yes, check for power and ground at the switch. You don't know where to start unless you know what you have. If the truck was crashed you could be chasing something in the harness.

Share this post


Link to post
Share on other sites

Just found out something else is not working.... the memory seat is not working. I adjust everything, i press set then press 1. And then i move my seat in a different position to see if it will work by holding number 1, and nothing. Just stays in the position i moved it too. Ive also tried the same for setting 2. Does the module under the seat control the memory seat and the heated/vented switch? Just fyi... i have gone into the setting on the radio to have auto recall on and still doesnt move into postioon after setting it up. Any help will be grateful. Thanks

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×

Important Information

By using this site, you agree to our Terms of Use.