Jump to content
  • Sign up for FREE! Become a GM-Trucks.com Member Today!

    In 20 seconds you can become part of the worlds largest and oldest community discussing General Motors, Chevrolet and GMC branded pickups, crossovers, and SUVs. From buying research to owner support, join 1.5 MILLION GM Truck Enthusiasts every month who use GM-Trucks.com as a daily part of their ownership experience. 

Recommended Posts

Look up belltech and McGaughy lowering kits, they should let you know what you are going to need.

 

A rear flip kit will get you the 4-6in rear drop with ease. Some modification to the bump stop bracket is required.

 

The front is likely a drop spindle and lowering strut to get you the from drop you require.

 

Past that do more research on the this forum for what you need to do. There are several threads on these topics to browse through. And no matter what it's going to cost probably $500-800 for parts and alignment work.

Link to comment
Share on other sites

7 hours ago, BrooklynBowTie said:

What’s the cheapest most efficient 3/5, 4/6 lowering kit or drop for a 2014 Silverado crew cab standard bed 2wd 5.3???

If you want to do it cheap than you need to stay on many different forums and eBay and wait on a used kit to come available.

Other than that you will be as talked about above $500-$800 for it to be correct and new. Flip kit by itself is going to run you $300 unless you go 7 in.

7" you can leave the stock stuff and just flip the axle. Bump stops will need modified, that can be done cheap!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Similar Content

    • By Cody G
      I have a 2021 6.2 Chevy Silverado, and just did a muffler and flapper delete. Sounds amazing but is way to loud on the highway and drones way too much for me. I am wanting to put a muffler back on but I want one that is as loud as I can get with no drone. I was looking at the Flowmaster 50 Delta Flow, the 40 series delta flow, or a Magnaflow 22 inch muffler... I am wondering the pros and cons of all of these, if they drone, and how loud they really are. I have watched a bunch of Youtube videos on them and they just don't do a justice for how loud the drone is. If you guys have any other suggestions for what to put on there I am open! Thank you!
    • By graves4wheeler
      2015 Silverado no crank no start with key. (have engine light on dash and also have u422) have replaced starter and battery. have 12.5 volts at the starter. checked 2amp fuse in dash for ignition switch, checked under the hood 15amp fuse that powers the ignition switch, checked the 60 amp fuse in fuse box. also checked the 40 amp fuse, checked starter relay in fuse box under hood. tried jumping starter relay post and got nothing. have 12.5 volts at power leg of starter relay, have ground on ground leg of relay. can jump starter solenoid with screw driver and truck runs and drives. 
       
      gear shift selection shows park when in it and neutral. Anybody have any ideas of what could be going on?
    • By Disposable
      Any help before I have to leave the truck at the dealer for a few days would be great. 
      2017 Silverado
      Dual 7 pin and 4 pin connector
      Test the 7 pin :  8 volts when grounded to the wiring harness
      Test the 4 pin : 7-8 volts when grounded to the wiring hardness
      Test the 7 pin :  8 volts when grounded to the Frame
      Test the 4 pin : 7-8 volts when grounded to the Frame
       
      7-8 Volts on when testing at the fuse panel  under the hood. Grounded to the engine block. 
      Relay seems good, all 4 fuses are good.  Other Fuses like lights, radio and wipers all bring back 12v range. 
       
      I am not sure where to go from here. I don't want to miss a ground wire or something. 
      I did clean and re-attach the ground wire next to the brake controller under the rear of the truck. 
       
      Thanks, 
       
       
    • By kevymetal
      I have a 2021 Silverado 1500 Custom. As soon as it starts getting cold outside (around or just below freezing) the screen on my back up camera frequently goes green. Brought it into the dealership last winter and they couldn't recreate the problem so they weren't able to do anything. Anyone else have this happening and know if there is a fix?

    • By Danny From Canada
      I’m looking at purchasing a ‘22 Elevation.   Unfortunately the truck I’m looking at isn’t equipped with the dual exhaust/bumper, which is what I want.  It just has the regular pipe out the side.   Does anyone know if the dealer can swap out the bumper and add the dual exhaust?  
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    240.6k
    Total Topics
    1.4m
    Total Posts
  • Member Statistics

    298,719
    Total Members
    8,960
    Most Online
    Rdelia
    Newest Member
    Rdelia
    Joined


×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.