Jump to content
  • Sign up for FREE! Become a GM-Trucks.com Member Today!

    In 20 seconds you can become part of the worlds largest and oldest community discussing General Motors, Chevrolet and GMC branded pickups, crossovers, and SUVs. From buying research to owner support, join 1.5 MILLION GM Truck Enthusiasts every month who use GM-Trucks.com as a daily part of their ownership experience. 

Recommended Posts

I started with a led glow system and used the interior tubes for this install. Silicone the ends for water profing used 4 of the 12 inch led tubes . Led glow includes brackets for the tubes so I was able to use them and it makes it easier to angle the lights correctly. In those vents I used a couple 9 inch led strips with 3m on the back I just needed to integrate them into the led glow system . I removed my grille for easier installation just remove piece between grille and rad make sure you take off the hood release then 4 10mil bolts and about 6 clips once you have the bolts out just grab the grille and pull straight back. They are installed on the top edge of the letter cutout and angled towards the letters. I’m not big on all the light lighting up behind grille so I might block that to prevent light from spilling back.

Edited by [email protected]
Add info
Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.