Search the Community
Showing results for tags '1989'.
Found 7 results
Can I use a nv4500 bell house on a sm465 5 speed is fuped. If so cant I just use my existing master line and slave system 1989 k1500 155.5 wheelbase np241c getrag290 5 speed
Anyone help with battery tie down used in 1989 S15? I can't figure out what factory method was used to secure battery in place. thanks
OBS Chevy Silverado
Ol' Red posted a topic in New Member IntroductionsI'll start this off i have a 1991 chevy silverado k1500 what is the biggest size tire i can fit on it with a 3 in body lift im about to put on it with 15 inch rim?
1989 GMC K1500 SLE - almost everything is new/rebuilt
Turbo Dog posted a topic in For Sale/WantedI have owned this truck for about 15 years. It started out as a daily driver, then work changed to a travel position and it went to the airport once a month. About 5 years ago I bought another truck so this one doesn't get driven much anymore. It is very dependable, just look at the list of what has been done to it while I owned it. I used to make my living as an ASE certified Master Automotive Technician, and then I went on to do development work for GM at the Desert Proving Ground. I have all the receipts for the work that has been done. I can help with shipping if you live in a different part of the country. This is a solid RUST FREE truck. 350 engine out of a 1994 K1500 with about 140K miles on it. The transmission was already rebuilt when I bought the truck. Rebuilt transfer case Rebuilt rear end - new gears, new bearings, new limited slip diff, new axels, new brakes, new drums and hardware - all that was kept was the housing and brake backing plates Tires were put on last year, Firestone Destination A/T with only about 1000 miles on them New spare tire and custom bed mount All the computer sensors on the engine have been replaced New alternator, not rebuilt New Starter, not rebuilt New water pump, not rebuilt All the engine rotating items have been replaced except the power steering pump Right side wheel bearing and ball joints New Optima red top battery Custom made front bumper with a receiver hitch and .120" wall DOM tubing The down side...the paint is the typical peeling paint for that year. Sand it off an put on a new coat, the body is nice and straight. Only things that don't work are the AC and cruise control. $3800.00
GMC Jimmy - 1989
aanung posted a topic in 1982-2005 Chevrolet S-10/Blazer & GMC S15/Sonoma/JimmyHey. Bought a new project today. Must take some rust and maybe new paint.
WANTED - GMC Center Cap - 6 lug
bradyjames posted a topic in For Sale/WantedThe center cap on my 1989 GMC fell off while I was driving down to San Diego. I am looking to replace it but I am having a very hard time finding the 6 lug center cap model. If you have one for sale or happen to have one lying around the garage please contact me at [email protected] and maybe we can work out a negotiation. I have attached a picture of what I am looking for. Thank you, Brady James
im at my wits end with my 89 k2500 need some help.
topumpchump posted a question in Ask the GM TechnicianI have a 1989 k2500 5.7 tbi with 171,xxx miles on it. I've had no issues with it until a month ago when the engine is under load it cuts out, as soon as I let off it back fires and everything is normal. I've replaced cap and rotor, plugs and wires, coil, egr valve and solenoid, map sensor, tps and fuel filter trying to track down the culprit. Ran the codes, it came back with code 34 map sensor. Unsure why, cleared the codes and it throws it again. The truck idles just fine just won't drive well. I should probably also include that the truck has no cat anymore and is 3" straight pipped back to a flowmaster. Unsure if that will make any difference with help as it had had this set up for over a year prior to any issues. Please help, I'm not used to these tbi systems but more familiar with old school engines that only need suck, blow, bang to run correct.