Jump to content

Yogiarana

Member
  • Content count

    8
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Yogiarana

  • Rank
    Enthusiast

Profile Information

  • Name
    Yogi
  • Location
    Los Angeles ca
  • Drives
    2014 chevy Silverado regular cab
  1. What's needed to add parking sensors???

    I'm in the same situation but dont really care about getting them to work is there anywhere that sells just inserts so it looks like you have them instead of just holes?
  2. Painting interior trim

    If done right it should hold up fine debating on painting or wrapping. Did you do grille and bumper too? Sent from my SM-G955U using Tapatalk
  3. Painting interior trim

    Yea but if I was gonna paint the interior I'd do it with all the preparation with the soaps sanding down and all that it be more then just $5 so probably cheaper to just wrap it Sent from my SM-G955U using Tapatalk
  4. Painting interior trim

    Do you know roughly what the cost difference is between the two ? Sent from my SM-G955U using Tapatalk
  5. Painting interior trim

    Yea for the exterior I'm getting it wrapped just since its chrome but the interior I would like to do it myself Sent from my SM-G955U using Tapatalk
  6. Painting interior trim

    Makes sense but I cant sell my truck I have a notched frame I'm stuck with it[emoji23][emoji23] Sent from my SM-G955U using Tapatalk
  7. Painting interior trim

    Was this chrome before you painted this? I wanted to do this also but was told painting chrome was not a good idea since it chips and I was better off wrapping it
  8. Hey guys a I drive a 2014 Silverado regular cab and recently installed belltech's rear flip kit and djm control arms. I'm getting some vibration around 65mph and have done some research and figured it was my pinion angle. My question is do you guys know what the correct angle should be and how many degrees the driveshaft and how many degrees the yoke should be? Also in my kit they included a shim that I believed should have been installed with the thicker side to the front but read some where that when lowering a truck the thicker side should be towards the rear. Does anyone know which way it goes? Sent from my SM-G955U using Tapatalk
×

Important Information

By using this site, you agree to our Terms of Use.