Jump to content

casale33

Member
  • Content Count

    26
  • Joined

  • Last visited

Community Reputation

0 Neutral

About casale33

  • Rank
    Enthusiast

Profile Information

  • Location
    Array
  • Drives
    Array

Recent Profile Visitors

1,932 profile views
  1. In reference to your post about your 2011 with the faulty yaw sensor, could you tell me where this sensor is located? I’m having a similar problem with my truck 

  2. No it's idling correctly now. Thanks
  3. Yes thank you. After slowly reading the TSB again I saw the step relearn idle step , so I hooked up my scan tool and its ok. There is a GM special warranty on the tp sensor for up to 10 yrs 100,000 miles ! So there reimbursing me the part.
  4. i did read the TSB IT SAID 2011 AND UP DOESNT NEED TO be REPROGRAM , is that correct?
  5. yes truck is driveable ,no codes until i press throttle high and releass and it stays at 2500 rpm then it sets code p0507.. and no issues with battery other then at cold morning starts it seemed week at crank
  6. MY 2O11 SILVERADO STARTED SETTING THE CODE 2135 MOSTLY IN THE AM , WAS CLOSE TO TIME FOR NEW BATTERY SO REPLACED THAT STILL CODE SETS WITH THE REDUCING ENGINE POWER ECT ..TSB STATED REPLACING TPS AND I DID TO ALL SPECIFICATIONS STATED AFTER INSTALL VEHICLE IDLE OK BUT TOUCH GAS PEDAL AND RPM RACED TO 2500 AND STAYED THERE .. IS THIS JUST A RELEARN PROCESS ? TSB SAID 2011 AND UP Would not need ecm reprogram thanks for any help
  7. casale33

    CO710

    gotcha,, thanks i will try
  8. casale33

    CO710

    Thanks. Do you have a copy of TSB info.
  9. casale33

    CO710

    yes ,, also had a alignment done to make sure ...does not pull or vibrations
  10. casale33

    CO710

    yes ,, had the scanner diagram show accurate angle readings with wheel..mil can go weeks without setting ,, any ideas ,,,,bad angle sensor ?
  11. casale33

    CO710

    i had it scanned and that was the code
  12. casale33

    CO710

    I HAVE 2011 CREW CAB silverado, once and awhile the dtc trips the co710 code [ steering position signal] which usually resets at next key cycle .. is this just a bad switch or could it be something else? i appreciate any help ..
  13. 2011 silverado crew cab,the park assist module was damaged under pass seat and i replaced it. code b101e/b1015 come up ,vin on module not matching bcm , whats the procedure/options for this , any help would be appreciated. its out of warranty, thanks
  14. ok thanks,, i originally started looking at the drivers side for the fault, checking connectors ect,even changed clock spring for the hell of it even tho it ring out but then i seen numerous gm posted dtc list referring b0013 ,12 to the pass/frt right air bag....so ill go back to the driver/steering wheel air bag and thoroughly check with your provided instructions ..i appreciate your help
  15. just to follow up on .. check wiring ok , ordered seat poss sensor, installed and it cleared b0079 code.. thanks for info.. still have b0012 b0013 code, i check connections to pass front air bag, seem ok are those codes def for front/pass deployment loop stage 2 or have they been switched around thanks
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.