MurphUmp47

My pads wore quickly and I found the wear sensor to be reasonably accurate. I've gone through an unusually hi number of pads over 80k of driving without a known cause. I'm a little bit of a heavy pedal guy but not crazy.

Hello. I mistakenly due to brute force pulled a lead out of the car harness side connector to the rear brake wear sensor (i.e., what the below left end plugs into on the truck behind the backing plate). I'd rather splice in a pigtail to the correct connector, then hard wire the wear sensor into the chassis harness as has been suggested to me. Does anyone know what the type of connector is called and perhaps where I can find one, preferably pre-wired with pigtails? The chassis cable part this includes for the truck is expensive and is requires extensive wire loom removal and replacement on the rear half of the truck to route properly. Thanks.