Search the Community
Showing results for tags 'torque spec'.
-
Hopefully someone can help me, I made a dumb mistake of loosening the clutch lever pivot pin on my Sierra 1500 transfer case. Transfer case is a np246. I kid you not I have looked online for hours looking for the torque spec of that clutch lever pivot pin. Just want to torque it back to where is was. If anyone knows the torque spec for it I would greatly appreciate it. Below is a diagram of transfer case, #13 is the clutch lever pivot pin
-
- Sierra 1500
- np246
- (and 5 more)
-
I just finished installing the ACDelco 45G2019 stabilizer links on my 2006 GMC Sierra 1500 2WD WT. The issue im having is tightening them down to the right torque spec. The instructions say 20 ft lbs but as im tightening them, im not getting any clicks, the bolt just keeps turning and it feels pretty much the same tightness the entire time. The bolt started sticking out the top about an inch so i just stopped. Should i just keeping going to see if it gets tighter? Should i back it off a bit? Really confused as my old links bolts only stuck out about 1/8in but not sure if that was because of the wear and being looser. If anyone is familiar with installing sway bar links, i'd appreciate some help. Also, im doing this with the vehicle on the ground.
- 1 reply
-
- stabilizer link
- suspension
-
(and 1 more)
Tagged with: