Jump to content

metalfan

Member
  • Content count

    8
  • Joined

  • Last visited

Community Reputation

0 Neutral

About metalfan

  • Rank
    Enthusiast
  • Birthday 07/19/1978
  1. Rebuilt the Tbi unit today, all is well
  2. Went ahead and did the fuel pump. Cut an access panel in the bed. Measurements were a bit off from the youtube video, but not too bad. The hesitation seems to have been rectified.
  3. It actually looks like a good method, I may find a way to reseal it and give it a shot. It's just a work truck anyway.
  4. I just watched some videos of some guys that cut a square hole in their bed to access the fuel pump. Lol
  5. I might try lifting the bed too
  6. Yea, I have seen that too. I just filled mine up as well
  7. Thanks for the reply. That would be my next step, I was hoping to avoided the fuel pump swap, but such is life.
  8. I could use some advice on this. I recently bought our 92 sierra work truck from my boss, I have a hesitation when accelerating after I have driven it for about an hour. Done -cap, rotor, plugs, wires -Air filter -o2 sensor -throttle position sensor -coolant temperature sensor -ignition control module -oil and filter -fuel filter -muffler -catalytic converter -cleaned egr valve -fuel pump replaced about 12 yrs ago It runs great for 30-45 minutes. Any ideas would be greatly appreciated
×

Important Information

By using this site, you agree to our Terms of Use.