Grant S

Now I have a similar problem putting the covers on the headrests. The pre-cut hole for the tilt button on the headrest cover is way too small to stretch over that button. If I could take that ring off that's around the button, the cover would go on so much nicer. All my searches come up with is how to remove headrest which I already know how to do. Any ideas? PROBLEM SOLVED. I WAS ABLE TO STRETCH COVER OVER THE BUTTON WITHOUT DAMAGING THE NEW COVER. THANKS

i wasn't able to remove those headrest mounts with that procedure GEMARSH shared, but the way this guy shows it done in his seat removal video worked. still a little tricky, but doable. made installing the seatcover much easier and avoided cutting the holes bigger. https://www.youtube.com/watch?v=qP3flj4YGoE&t=93s

thank you so much. I knew there had to be some way to get those out. i'll give this a try tomorrow.

How did you get the rear seatcover tucked under the headrest trim? The front headrest trim comes off, but the rear headrest trim doesn't appear to come off and the pre cut holes on my new vertex seatcovers are barely bigger than the headrest posts and no way will they stretch over the trim. I am hesitant to cut the holes bigger and assume there has to be some way to remove the trim pieces. Any help here is appreciated so I don't have to call vertex customer service