Search the Community
Showing results for tags '2015 silverado'.
-
Hey Everyone, Have a weird one here on my 2015 Silverado LTZ. Running light (right side only) isn't working, but brake/reverse/blinker all do. Replaced the following with no luck: Relay 63 Fuses 28 and 29 Junction Block - Part number 23208491 Right wiring harness - Part 22869169 (replaced because I broke the dang clip taking it apart) All of the other wires at the junction plate appeared to be in good condition. Vehicle is stock. Any ideas would be greatly appreciated. -
Bringing up an old post I found and hoping to get some help.. I'm having an issue with the following set-up: 2015 Silverado, Black Widow edition - 6" Fabtech & 35x12.5x20 MT ATZ's. I bought the truck last week and noticed the wheels hopping/sliding when fully turning left or right. Thinking it was an alignment issue, I brought it back to the dealer to check. They made some minor adjustments but nothing was out of GM spec and the problem remained. I contacted Fabtech to see if there were any other specs i should use for the alignment other than what the manufacturer recommends after the lift but they said "not really". i did get the alignment specs for one of the trucks they (Fabtech) own with the same lift and the only thing i can see different than mine is the slightly increased caster angle. No idea what the issue is but very annoying and sure it will wear my tires prematurely. Based on my knowledge, it seems like whether turning left or right the outer wheel is over-steering and/or the inner is under-steering causing the outer to either slide or hop. Driving straight or in slight turns is great. Only see the issue at full turn. Also lost turning radius but kinda expected that with the lift/tires. I'm sending Fabtech pics of tread marks and tire wear and see what they recommend. Seems like the Ackermann angle is off but not sure where to start with ruling it out. The truck is back at the dealer today to align according to the Fabtech specs but not sure what to expect when I get it back. Always in 2WD and rarely use the auto 4WD feature. Disengaged the traction/stability control to see if anything changes but nothing. Other than that...Stumped Pic is of the skid marks left after turning left. Same is happening at a full right turn. -
If you had a 2015 Silverado 1500 CrewCab, would you keep it or get rid of it for a 2013 GMC 2500 HD Denali Crewcab if you had the opportunity?
-
The evaporator in my 2015 Silverado went out and I do not see any videos or anything to see on how to do it, does anyone have any info on this??
-
The evaporator in my 2015 Silverado went out and I do not see any videos or anything to see on how to do it, does anyone have any info on this??
-
McGauphy Lift VS Rough Country Lift
2014Sandylifted posted a topic in 2014 - 2019 Silverado & Sierra
So I wish too debate which lift is better, since they very close in price. Who is running what tire setup with which lift and how they have use the setup as well. Also how they feel the ride is with the lift and tire an wheel set up you have. I am leaning toward the McGauphys due too I want to run it at 8"s with 35x12.50R20Lt's. POST PIC's OF YOU'R SET UP. -
Hi All, I'm deciding on tires & would love any of your thoughts. I have a 2015 Silverado with 2.25" front level & 3" rear blocks (removed the 1.25" blocks). I'm leaning toward the BFGoodrich All-Terrain T/A KO2 for the Snow/ice traction (Please, Let me know if you agree or disagree for any reason). I'm also deciding on the size. I know 275/60R20 32.99" tall will fit. I would like to know if I can go up to 275/65r20 34.07" tall? Both sizes are 10.83" wide on stock 20" rims. Has anyone done this with a similar lift? -
Some of you might have seen my post asking for input before I bought my truck... Well, I bought it and I just made a short video to show you... Check it out and let me know what all info I fumbled, haha! https://www.youtube.com/watch?v=gY-cL1HkTtc- 5 replies
-
- 2
-
-
- 2500hd
- 2015 silverado
- (and 4 more)
-
Hi, has anyone installed Borla 2.75" Inlet x 2.25" Outlet (Touring Cat-Back Exhaust System) with Tips for 2014 & up Chevrolet Silverado/GMC Sierra? Interested in your thoughts &/or other's I should consider? This part#140544 is the dual side exit on a double-cab 6'5" standard bed.
-
2015 Silverado. My link system. Disconnected the battery yesterday for a few minutes. Since then, I can set AM and FM presets, but not XM. XM plays fine, but have to scroll to find stations. Is there something I'm missing?
-
Hi, installed Husky Liners 53111 X-act Contour Black Front Floor Liner & Husky Liners 53911 Black X-act Contour Series 2nd Seat Floor Liner (Full Coverage) 2015 Silverado Double-cab. In January 2016.
-
Hi, installed Razer Auto 2014-2015 Chevy Silverado 1500 Chrome Taillight cover June 2016.
-
Hi, installed the Lund 96893 Genesis Elite Roll-Up Tonneau Cover. November 2016. 2015 Silverado 6'5" bed.
-
Hi, Installed WeatherTech side window deflectors #82740. 2015 Silverado Double-Cab. October 2015
-
Hi, Installed WeaterTech MudFlaps No-Drill DigitalFit #110035-120035 . October 2015.
-
- 1
-
-
- mudflaps
- 2015 silverado
- (and 1 more)
-
Hi, Installed Dee Zee #DZ99612 Stainless Steel Side Rail. February 2016. 2015 Silverado 6'5" bed.
-
Hi, Installed ReadyLift on my 2015 Silverado. 2.25" front lift #66-3085 and removed the factory 1.25" rear blocks to install ReadyLift 3" rear blocks #66-3003. Also added the ReadyLift rear 1.5" Shock extensions #67-3809 to maintain the factory ride. Then a 4-Wheel Alignment. Also replaced my CURT #45030 Class 3, 2" drop ball mount with a CURT #45050 Class 3, 4" drop ball mount to keep trailer level. September 2017. Attached before & after Pics.
-
FOR SALE Steering Wheel - Black Leather, Without Heat, Without Collision. This came of of my 2015 Silverado Z71 LT because I upgraded to a wheel with heat. Everything is in perfect condition with no wear on buttons or any issues to speak of. I'll also throw in the clock spring as well. Clock spring is in working condition, but I cut the cords in half out of frustration when I was removing it...LOL! $140 shipped (assuming it's within the lower 48 States) -
So after getting my truck back last Thursday, I now (Monday it started) have this problem... and since my warranty is out they want to charge me after they just had it replacing the transmission control module and reprogramming. I have a video but it’s too large to load on here. The LED bar that does running lights, turn signal and brake, and backup lights is all working fine... even the right turn signal on it is good. That bar is hooked up to my trailer hitch which at this point must be ran off another relay or circuit since it worked fine until the dealer said to remove it before we went further. The running lights all around work fine, and the left and 3rd brake light work perfectly. The issue is the passenger brake light is illuminating constantly like the computer thinks I’m braking to that light only which kills my battery... it will not go off at all. After pulling the bulbs out so the truck doesn’t die, I now get an indicator at the dash that there is a light out when I put the turn signal on. So the computer obviously sees the resistance of the bulbs just fine. If there was a short it wouldn’t see the bulbs and throw that indicator with them in, I would think?! I did car audio and alarms and stuff when I was younger so I know a little about the electric system, but these days everything is tied to a computer so I’m thinking it’s related to that in some way. I do home audio video Service and programming now so I’m racking my brain to find what makes sense to me before I go ripping the truck apart and not finding the issue, or it is the computer that could be a quick fix possibly. Or maybe this is an extension to the 2.7 million recalls they had on brakes from previous years and just not part of it yet. Hopefully someone has seen this! Any help is appreciated, even a wiring diagram that can lead me in the right direction would be helpful. 2015 Chevy Silverado 1500
-
I get a lot of wind noise on all doors of my 2015 Silverado. The door seals have been replaced and no difference. Has anyone else had this issue or know of a fix for the issue?
-
From the album: Silverado
-
**** let me upload pics on tapatalk really quick **** I'll have 275/55R20 Duratracs, think most of these wheels are coming in either +18 or 0 offset. I dont want the tire sticking out though so im looking at 18. Ive been going back in forth as well as finding new ones daily. I just need to make a decision. Ive narrowed it down to 6 right now in no particular order. If I can find pics of a silverado with the wheel ill include just for reference. I kno some arent my year of truck or setup either just looking at the tire. Ultra Baron Fuel Maverick (everyone has these tho) Black Rhino Peak Ultra Goliath Ultra Maverick Moto MO951 Also open to any suggestions
-
I am selling my set up from my 2015 Silverado since I lifted it. This is from the midnight edition and has 7k miles on them. Rims are 18s and tires are Goodyear Wrangler Duratracs 265/65R18. This set up is in new condition, ready to mount, and also has the tire pressure sensors. Price is 1,600 for local pickup only. Text for pics. 718-689-3559. Located in Staten Island NY. -
Well I know its not the time of year but it is coming. I bought a brand new 2015 silverado work truck with the plow prep package on it. I traded in my 2013(biggest mistake) and had the plows swapped from the 13 to the 15. When drivng over 40 mph (in the winter) the temp starts to climb to dangerous numbers. I had the GM engineer involved in this problem and they are aware of it but have no cure. There answere was not to drive over 40MPH. Speed limits on the way to work ar 55 MPH. The engineer said that at 40 MPH the plow creates a vacuum and pulls heat from the engine through the radiator. The difference I have noticed was the 2013 had holes in the bumper and the 2015 does not. This only happens on the 1/2 tons due to the 25-35 has holes in the bumper for the cooler. Any one else have this problem or a fix?
-
Hey y'all , like the topic said I'm looking for a terminal eyelet used on the battery fuse box on a 2015 Silverado 1500 (see attached). I have found the harness number ( Part Number: 23479826) and have been to every battery place around here including 2 dealerships parts department trying to find them. So my question is does anyone know of a part number of these terminals and where i could find them. I'm trying to keep every factory looking and i don't want to have to hack the fuse box just to get 12v off the battery. Thank you in advance for any help you can provide.
