Search the Community
Showing results for tags 'rear door latch'.
Found 2 results
So I have a 2008 Silverado 1500 LT 5.3 Extended Cab Texas Edition. I've had the truck going on 8 years now, but the trim has started to get loose. I've replaced body clips but some of the plastic has begun to break. I've searched junk yards, and auto lots with no luck to replacement. I tried GMdirect for the trim but still unable to find interior trim for this truck. It shakes and rattles over bumps like crazy, back door trim fell off. I've used foam to help quiet the rattling but if the trim doesn't stay on, there's no point. Might be from the back doors rattling (cannot figure that out either). Does anyone have a website link other than GMdirect for where I can find the interior trim replacement? Thank you!
Right rear door ajar message
John-1500HD posted a topic in 1999-2013 Silverado & Sierra 1500I’m troubleshooting a Right rear door ajar message on my 2003 Sierra 1500hd. I’ve looked at the wiring diagram and am more confused now! Here is what I have done and the results: All doors closed, start truck, put in gear, receive message: Right rear door ajar. All doors open, start truck, put in gear, receive messages for each door...which is what I would expect I then unplugged the connector to the BCM (located above the brake pedal) and did the following test: All doors closed, start truck, put in gear, receive message: Right rear door ajar. ??? How does it know anything? All doors open, start truck, put in gear, receive messages: Driver D A, Pass D A, Right rear door ajar . How does it know? Why did it not say the left rear door was ajar? I opened the door panel and verified the ground was good and then it got more weird. According to the wiring diagram, the lead going to the BCM from the Right rear door is Lt. grn/blk. Well it is Lt.grn/blk at the BCM connector, but at the door it is Lt.blu/blk. So I checked the left door. Diagram says it is Lt. Blu/blk and that is correct/ what I found. Conclusion: Even though I was surprised by the wire color everything toned out ok. So while I think the problem is with the door latch or the BCM, I really need some suggestions.