15z71night

Im pretty sure I read that too.. but I threw on 285/55 22 and rubbed only on the sway bar being it at full lock, not the control arms. Just a slight rub. Anyone else looking a this kit.. iv had it on the truck for prob. 30k, 40k miles,. When we get snow I just throw it in 4wd and it doesn't sound any different then when it was stock. When I installed this kit a while back, I'm pretty sure the knuckle itself was taller but not by much, maybe 1/2in, 3/4.. I could be wrong, maybe,... but I did notice the lower ball joint spot was angled down vs oem was flat to help with that angle.

its +24 offset for the OEM 22

im not sure if anyone has had an issue with rubbing. but ill give a little background on the truck, 2015 z71 CC - 3.5 RC lift - OE 22 with 285/55 ridge grapplers - Zone fender plates - pocket fenders so i was ok for a long time and the only rub i was getting was on the sway bar both sides. i wanted to fill out the pocket fenders so i added 2in hubcentric spacers. the only rub i have now is rear of the drivers side fender, the passanger side has about a good 3/8 to 1/2in clearance on the same spot. im confused as to why its only the drivers side rubbing?

are you running any wheel spacers?